紫外光引发低密度聚乙烯接枝聚N-异丙基丙烯酰胺的温敏改性
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51463005);贵州省科学技术基金(黔科合J字[2014]2051号及黔科合J字[2014]2054号);贵州省研究生教育创新计划(黔教研合JYSZ字[2014]001)


Low-Density Polyethylene-Grafted Poly (N-isopropyl acrylamide) Initiated by UV Irradiation
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以二苯甲酮(BP)为光敏剂,采用两步表面光接枝法将N-异丙基丙烯酰胺(NIPAAm)单体接枝到低密度聚乙烯(LDPE)表面,赋予LDPE表面温敏性。通过红外光谱和扫描电子显微镜等对LDPE-g-PNIPAAm的结构进行了表征;采用调制差示扫描量热分析技术和表面水接触角测定法研究了LDPE-g-PNIPAAm的温敏性;讨论了引发剂浓度、光还原时间、单体浓度和光照时间对接枝率的影响。结果表明,LDPE-g-PNIPAAm具有温敏亲/疏水性,其低临界溶解温度(LCST)在33 ℃左右。增加引发剂浓度、单体浓度、延长光还原时间和光照时间都能使接枝率增加;且可以通过调节这4种因素来控制接枝率。

    Abstract:

    Benzophenone(BP) was used as photoinitiator, and N-isopropylacrylamide (NIPAAm) was grafted onto the surface of low-density polyethylene(LDPE) by two steps photografting polymerization, given the LDPE surface thermoresponse. The structures of LDPE-g-PNIPAAm were characterized by Fourier transform infrared spectroscopy and scanning electron microscopy(SEM). Thermoresponse of LDPE-g-PNIPAAm was studied by modulated differential scanning calorimetry(MDSC) and water contact angle measurements. The effects of initiator concentration, photo reduction time, monomers concentration, as well as UV light irradiation time on the grafting ratio were discussed. The results show that LDPE-g-PNIPAAm has a thermoresponsive hydrophilicity/hydrophobicity with lower critical solution temperature (LCST) at about 33 ℃. The grafting ratio is improved with increasement of the initiator concentration, photo reduction time , monomers concentration, and UV light irradiation time, which can be controlled by adjusting these four factors.

    参考文献
    相似文献
    引证文献
引用本文

邱瑜, 雷华, 徐涛, 谭鹏.紫外光引发低密度聚乙烯接枝聚N-异丙基丙烯酰胺的温敏改性[J].高分子材料科学与工程,2017,33(2):22-27. Yu Qiu, Hua Lei, Tao Xu, Peng Tan. Low-Density Polyethylene-Grafted Poly (N-isopropyl acrylamide) Initiated by UV Irradiation[J]. Polymer Materials Science & Engineering,2017,33(2):22-27.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-02-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司