Abstract:Solid state shear milling (S3M) technology in combination with cryogenic pulverization was used to prepare the co-powders of nylon 12 (PA12) with carbon nanotubes (CNTs) suitable for the selective laser sintering (SLS) and the corresponding sintered products. The laser scattering particle analyzer, scanning electronic microscope (SEM), transmission electronic microscope (TEM), dynamic mechanical analyzer (DMA), Fourier transform infrared spectrometer (FT-IR) and differential scanning calorimeter (DSC) were used to characterize the structure and performance of the obtained PA12/CNTs co-powders and the corresponding SLS samples. The results show that the PA12/CNTs co-powders prepared through S3M technology and cryogenic pulverization mostly have the ellipsoid shape, average particle size of 75 μm and SLS processing window of about 10 ℃, which satisfies the requirements of SLS process for the performance of the sintered material. The addition of 0.1% flow additive nano silica further improves the SLS processability of the prepared co-powders. Pan-milling realizes the cutting of CNTs, the better dispersion of CNTs in PA12 matrix and the grafting of CNTs onto PA12 macromolecular chains under its very strong three dimensional shear force field, remarkably enhancing the interfacial compatibility between both phases. In addition, the PA12/CNTs sintered products with smooth surface, complex structure and good property were successfully fabricated through optimizing the SLS processing parameters. The obtained PA12/CNTs SLS samples show the good mechanical performance, achieving tensile strength of 44.2 MPa and notched impact strength of 8.12 kJ/m2.