端基四肽聚异戊二烯的合成表征及流变性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51333003)


Synthesis, Characterization and Rheological Properties of Tetrapepetide-Terminated Polyisoprene
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    文中对四肽封端的聚异戊二烯的合成方法和流变性能进行了初步探索。首先采用新癸酸钕/二异丁基氢化铝/二氯二甲基硅稀土催化剂体系催化异戊二烯聚合,得到了相对分子质量可控,窄分布(1.09~1.4),顺1,4结构含量高(96%)的聚异戊二烯。聚合4h后用二氧化碳封端得到端羧基聚异戊二烯(PI-COOH)。非水滴定结果表明羧基封端率高(100%)。然后PI-COOH 与四肽(Boc-(ala)4-NH2)缩合形成端基为四肽的聚异戊二烯(PI-4A)。流变测试结果表明,与PI-COOH 相比,PI-4A中四肽的分子间氢键作用使得储能模量提高了约1000倍;并且在升温过程中氢键被逐渐破坏,模量快速下降,在50℃时大部分氢键断裂。

    Abstract:

    This article aimed to probe the synthetic methods and rheological properties of tetrapeptide-terminated polyisoprene. First a rare earth catalyst system composed of neodymium versatate, dimethyldichlorosilane and diisobutylaluminum hydride was used for the polymerization of isoprene, resulting in samples with controlled molecular weights, narrow dispersities and high cis-1,4 contents. After 4 h of polymerization, carbon dioxide was introduced to block the end, giving the carboxylic acid-terminated polyisoprene (PI-COOH). The non-aqueous titration experiment confirmed a high end-capping efficiency. Then PI-COOH was condensed with tetrapeptide (Boc-(ala)4-NH2) to generate the peptide-terminated polyisoprene (PI-4A). Rheological tests show that the storage modulus of PI-4A is 1000 times higher than that of PI-COOH due to the intermolecular hydrogen bonding interaction. And the storage modulus decreases quickly when the temperature increases because of the weakening of the hydrogen bonding. When the temperature reaches 50 ℃, most hydrogen bonding is disrupted.

    参考文献
    相似文献
    引证文献
引用本文

曾 建, 李世其, 黄光速, 徐云祥.端基四肽聚异戊二烯的合成表征及流变性能[J].高分子材料科学与工程,2017,33(7):1-5. Jian Zeng, Shiqi Li, Guangsu Huang, Yunxiang Xu. Synthesis, Characterization and Rheological Properties of Tetrapepetide-Terminated Polyisoprene[J]. Polymer Materials Science & Engineering,2017,33(7):1-5.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-07-20
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司