含磷本质阻燃硬质聚氨酯泡沫塑料的制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

河北省自然科学基金资助项目(E2014209239,E2014209280)


Preparation and Properties of Phosphorus-Containing Intrinsic Flame Retardant Rigid Polyurethane Foam
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以苯基膦酰二氯(BPOD)和乙二醇(EG)为原料合成含磷长链二元醇(P-polyol),用于制备含磷本质阻燃硬质聚氨酯泡沫塑料(RPUF),研究了P-polyol对聚氨酯泡沫塑料性能的影响。结果表明,使用P-polyol制备的聚氨酯泡沫,含磷量为1.82%时,极限氧指数达到24.7%;微型燃烧量热仪(MCC)测试显示,燃烧过程的热释放容量、总热释放量和热释放峰值均有所下降。热重分析(TGA)结果显示,在氮气中热分解后700 ℃的残炭量为22.6%,在空气中热氧化分解后700 ℃的残炭量为17.0%,较纯RPUF均提高了1倍以上。阻燃后聚氨酯泡沫的压缩强度比空白组提高了130%,并保持了原有的冲击强度,这一优点是众多添加型阻燃剂难以实现的。

    Abstract:

    A phosphorus-containing polyol (P-polyol)was synthesized with benzene phosphorous oxydichloride (BPOD) and ethylene glycol (EG), which was introduced into rigid polyurethane foam (RPUF) by in-situ chemical reaction. The effects of P-polyol on the properties of RPUF were investigated. The LOI reaches 24.7% with the phosphorus content of 1.82%, and the heat release capacity(HRC), total heat release (THR) and peak heat release rate (pHRR) of MCC test decrease obviously. The residue of TGA at 700 ℃ reaches 22.6% in N2 and 17.0% in air, more than one time of neat RPUF. Compared with neat RPUF, the compressive strength is increased by 130% and the original impact strength is retained.

    参考文献
    相似文献
    引证文献
引用本文

闫 莉, 刘 娟, 李青芳, 桑晓明.含磷本质阻燃硬质聚氨酯泡沫塑料的制备及性能[J].高分子材料科学与工程,2017,33(7):6-10. Li Yan, Juan Liu, Qingfang Li, Xiaoming Sang. Preparation and Properties of Phosphorus-Containing Intrinsic Flame Retardant Rigid Polyurethane Foam[J]. Polymer Materials Science & Engineering,2017,33(7):6-10.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-07-20
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司