Guanidine分子在燃料电池用阴离子交换膜中的应用
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

辽宁省科技厅博士启动项目(20141126);辽宁省教育厅科学研究一般项目(L2013153);抚顺市科学技术发展资金计划项目(20141115);辽宁石油化工大学博士启动基金(2013XJJ-006)


Application of Guanidine Molecules in Anion Exchange Membrane for Fuel Cell
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以壳聚糖(CS)和2,3-环氧丙基三甲基氯化铵(GTA)为原料,制备季铵化壳聚糖(QCS),将其与小分子游离胍(Guanidine)共混,借助戊二醛(GA)的化学交联作用,将季铵化壳聚糖中的氨基以及胍中的氨基交联,形成网状结构,由此制得含有不同含量Guanidine分子的交联QCS-G阴离子交换膜。实验过程中,对该膜的含水率、溶胀度、力学强度、电导率及耐碱稳定性等进行了详细的考察。结果表明,游离胍的引入可有效地提高膜的电导率和耐碱稳定性,同时降低了膜的溶胀度及含水率。其中小分子游离胍质量分数为2.5%的膜(QCS-G2.5%)在70 ℃时的电导率可达到6.58×10-2 S/cm;在10 mol/L NaOH溶液中浸渍72 h后该膜70 ℃测得的电导率损失仅为3.8%,离子交换量损失仅为3.82%,表明该膜的耐碱性能较好。

    Abstract:

    Quaternized-chitosan (QCS) was synthesized by using chitosan (CS) and 2,3-epoxy propyl trimethyl ammonium chloride as raw materials. By chemical crosslinking effect of glutaraldehyde(GA), a mesh structure was formed with the amino in the quaternary ammonium groups of chitosan and the amino in guanidine crosslinks. Thus a series of different ratio of QCS-G anion exchange membranes were made. The moisture content, swelling degree, mechanical strength, electrical conductivity and alkali resistance of the films were tested. The results show that the guanidine can effectively improve the conductivity and alkali resistance of membranes, reduce the swelling degree and water uptake. The electrical conductivity at 70 ℃ is 6.58×10-2 S/cm when the guanidine content is 2.5%. The electrical conductivity loss is 3.8% after soaking for 72 h in 10 mol/L NaOH and the ion exchange capacity of the film loss is 3.82%. It shows that the stability to alkali of the membrane gets significant improvement.

    参考文献
    相似文献
    引证文献
引用本文

邸慧双, 崔珺, 可春钰, 王吉林, 王璐璐, 封瑞江. Guanidine分子在燃料电池用阴离子交换膜中的应用[J].高分子材料科学与工程,2017,33(7):172-178. Huishuang Di, Jun Cui, Chunyu Ke, Jilin Wang, Lulu Wang, Ruijiang Feng. Application of Guanidine Molecules in Anion Exchange Membrane for Fuel Cell[J]. Polymer Materials Science & Engineering,2017,33(7):172-178.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-07-20
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司