聚(偏二氯乙烯-氯乙烯)多孔膜制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51603146);天津市科技计划项目(课题)(15PTSYJC00240)


Preparation and Properties of Poly(vinylidene chloride-co-vinyl chloride) Porous Membrane
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以聚(偏二氯乙烯-氯乙烯)[P(VDC-co-VC)]为成膜聚合物,N,N-二甲基乙酰胺(DMAc)为溶剂,采用非溶剂致相分离(NIPS)法制备了具有非对称膜结构的P(VDC-co-VC)平板膜,通过扫描电镜、纯水通量、截留率、接触角、力学性能等测试,研究了聚合物浓度及凝固浴温度对P(VDC-co-VC)平板膜结构与性能的影响。结果表明,所得P(VDC-co-VC)平板膜由表面皮层及大孔支撑层组成,上表面较下表面致密。提高聚合物浓度或升高凝固浴温度均能提高P(VDC-co-VC)平板膜表面的致密程度,进而改善对牛血清蛋白的截留率及膜通量恢复率。低凝固浴温度下所得膜通透性能较好。力学性能随聚合物浓度提高而增加,随凝固浴温度升高而降低。

    Abstract:

    Poly(vinylidene chloride-co-vinyl chloride) [P(VDC-co-VC)] flat membranes with asymmetric structure were fabricated via non-solvent induced phase separation method. Ultrafiltration performances of the membranes were characterized in terms of pure water flux, rejection rate, contact angle and mechanical strength. The effects of polymer concentration and coagulation bath temperature on structure and properties of prepared flat membranes were studied. The results show that the obtained P(VDC-co-VC) flat membrane is composed of surface layer and macroporous support layer. The top surface is denser than the bottom surface. Increase of the polymer concentration and coagulation bath temperature could increase the surface densification degree. The protein rejection rate and membrane flux recover ratio also increase. The mechanical properties are improved with the polymer concentration increasing and coagulation bath temperature decreasing. The coagulation bath at a low temperature leads to better permeation performance.

    参考文献
    相似文献
    引证文献
引用本文

陈 欣,刘海亮,黄庆林,肖长发.聚(偏二氯乙烯-氯乙烯)多孔膜制备及性能[J].高分子材料科学与工程,2017,33(8):171-177. Xin Chen, Hailiang Liu, Qinglin Huang, Changfa Xiao. Preparation and Properties of Poly(vinylidene chloride-co-vinyl chloride) Porous Membrane[J]. Polymer Materials Science & Engineering,2017,33(8):171-177.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-08-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司