剑麻纤维素纳米纤的制备及表征
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

广西自然科学基金资助项目(2015GXNSFAA139256,2016GXNSFAA380004);国家自然科学基金资助项目(21204013,21664006)


Fabrication and Characterization of Nanofibrillated Cellulose from Sisal Fiber
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    首先利用制浆法从剑麻纤维提取剑麻纤维浆(SFCP),然后通过对其化学预处理并结合高速搅拌的方法简便、快速、高效地制备了分散性良好具有高长径比的剑麻纤维素纳米纤(SNFC)。研究了氢氧化钠、SFCP以及氯乙酸三者用量比、氢氧化钠浓度和预处理反应时间对SFCP表面羧基接枝率、SNFC产率的影响。采用红外光谱、扫描电子显微镜、透射电子显微镜、X射线衍射和热重分析对所制的SFCP和SNFC的结构形态及性能进行了表征。结果表明,所得的SFCP具有纤维素I的晶型结构,直径约10~20μm,长度约1~2mm。羧基化过程的最佳优化方案是氢氧化钠水溶液的浓度为10%,SFCP、NaOH、氯乙酸三者的质量比为2∶1∶1,反应时间为3h,SNFC 的产率最高可达91.7%。所得的SNFC仍然具有纤维素I的晶型结构,结晶度为76.9%,直径在3~5nm,长度在几百纳米到几微米。SNFC的最初热分解温度为248.4℃,比SFCP的起始分解温度321.7℃有所降低,但是700℃时的残炭率达到23.9%。

    Abstract:

    Here, pulping method first was used to prepare cellulose pulp from sisal fiber (SFCP). Then, well suspensions of individual nanofibrillated cellulose (SNFC) was facilely and high efficently fabricated by combining pretreatment by NaOH and chloroacetic acid with further high speed mechanical disintegration. The effect of the concentration of NaOH, mass ratio of sisal fiber pulp, NaOH to chloroacetic acid, pretreatment time on the grafting ratio of -COOH of the SNFC surface and the yield of SNFC obtained was discussed in detail. The structure and morphology of the SFCP and SNFC obtained were characterized by FT-IR spectroscopy, TEM, SEM and XRD. The results present that the SFCP obtained with the typical structure of cellulose has the diameter of around 10~20 μm and the length of 10~20 micrometers. The optimal condition of the carboxylation process is that the concentration of NaOH is 10%, the mass ratio of sisal fiber pulp, NaOH to chloroacetic acid is 2∶1∶1, the pretreatment time is 3 h, the yield of SNFC is high up to 91.7%. The SNFC obtained is still celluloseⅠwith the crystallinity percentage of 76.9%,and has the diameter of around 3~5 nm and the length of several hundred nanometers even to several micrometers. The initial decomposition of SNFC is 248.4 ℃ lower than 321.7 ℃ of the SFCP, however, the char is high up to 23.9%.

    参考文献
    相似文献
    引证文献
引用本文

周昌兵,徐 阳,刘馨月,刘红霞,韦 春.剑麻纤维素纳米纤的制备及表征[J].高分子材料科学与工程,2017,33(10):130-134. Changbing Zhou, Yang Xu, Xinyue Liu, Hongxia Liu, Chun Wei. Fabrication and Characterization of Nanofibrillated Cellulose from Sisal Fiber[J]. Polymer Materials Science & Engineering,2017,33(10):130-134.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2017-10-29
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司