异丁烯醇聚氧乙烯醚与丙烯酸的竞聚率及共聚物链段分布
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Reactivity Ratio of Isobutyl Alcohol Ethoxylates with Acrylic Acid and the Segment Distribution of Copolymer
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以过硫酸铵(APS)为引发剂,在50 ℃对异丁烯醇聚氧乙烯醚(HPEG)大单体与丙烯酸(AA)进行低转化率(<15%)的水溶液共聚反应。用凝胶渗透色谱和高效液相色谱分别测定反应体系中HPEG和AA 剩余量。依据设计反应单体投料比,K-T 作图法处理数据,得到异丁烯醇聚氧乙烯醚(HPEG)与丙烯酸(AA)的竞聚率分别为:r1(HPEG)=0.017,r2(AA)=1.70。进而分析了HPEG与AA共聚物P(HPEG-co-AA)的链段微结构和链节分布。当投料比为1∶4时,二元共聚物P(HPEG-co-AA)中HPEG以1个单体单元存在。丙烯酸均聚形成的链段以3~15个单体单元的链段长度为主,链段数均长度为7.8。

    Abstract:

    Using isobutyl alcohol polyoxyethylene ether(HPEG) as macromonomer and acrylic acid (AA), ammonium persulfate (APS, 1%) as initiator, the copolymer with low conversion rate was synthesized by free radical polymerization reaction under the condition of 50 ℃water solution. By gel permeation chromatography(GPC) and high performance liquid chromatography (HPLC), the monomer amount of residual andmacromonomer conversion rate of copolymer were measured.And then according to the monomer feed ratio, the reactivity ratio was calculated through the K-T method. The results show that under the conditions of low conversion rate, the reactivity ratio of isobutyl alcohol polyoxyethylene ether (HPEG) with acrylic acid(AA) is r1=0.017(HPEG), r2=1.70(AA). Micro-structure and chains distribution of P(HPEG-co-AA) were analyzed when the feed ratio of HPEG and acrylic acid was 1∶4. In the main chain of P(HPEG-co-AA), the length of HPEG is one monomer unit. Acrylic acid forms segments mainly at less than 10 monomer unit segments. The average length of the acrylic acid is 7.8, dominated with 3~15 monomer units.

    参考文献
    相似文献
    引证文献
引用本文

王子明,尹东杰,毛倩瑾.异丁烯醇聚氧乙烯醚与丙烯酸的竞聚率及共聚物链段分布[J].高分子材料科学与工程,2018,34(2):19-23. Ziming Wang, Dongjie Yin, Qianjin Mao. Reactivity Ratio of Isobutyl Alcohol Ethoxylates with Acrylic Acid and the Segment Distribution of Copolymer[J]. Polymer Materials Science & Engineering,2018,34(2):19-23.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2018-02-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司