聚碳酸酯光学制品注塑成型的残余应力
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Residual Stress in Polycarbonate Optical Injection Molded Products
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用单一变量实验考察了不同注射工艺参数对光学制品双折射的分布规律,通过应力-光弹定律计算了对称轴上残余应力值。用Moldflow软件对制品成型过程中型腔内流场进行模拟,分析了厚度方向应力的变化。结果表明,沿熔体流动方向上,制品残余应力是逐渐减小的,浇口附近有应力集中;在合理工艺范围内,适当提高成型温度和模具温度,延长保压时间和冷却时间有助于减小制品的残余应力,保压压力和注塑速度应适中才能改善制品的成型质量。

    Abstract:

    The effects of different process parameters in injection molding on the birefringence of optical products were investigated by insingle variable experiments. The residual stress was calculated using stressphoto elastic law along symmetricalaxis in the flow direction. Flow field in the mold cavity was simulated by Moldflow software for analyzing the stress variation in depth. It is shown that the residual stress gradually decreases along flow direction while the stress concentration appears near the gate. Appropriately increasing melt temperature and mold temperature or prolonging packaging time and cooling time can reduce the residual stress. Moderating injection speed and holding pressure can reduce the stress near the gate and improve the quality of formed products.

    参考文献
    相似文献
    引证文献
引用本文

王克俭,曹国荣,杨光威,刘顺城.聚碳酸酯光学制品注塑成型的残余应力[J].高分子材料科学与工程,2018,34(2):88-92. Kejian Wang, Guorong Cao, Guangwei Yang, Shuncheng Liu. Residual Stress in Polycarbonate Optical Injection Molded Products[J]. Polymer Materials Science & Engineering,2018,34(2):88-92.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2018-02-24
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司