Abstract:A linear silicon modified polyurethane oligomer was prepared from dimer acid diisocyanate(DDI), (3-mercaptopropyl)trimethoxysilane(PropS-SH) and hydroxyethyl methacrylate (HEMA). Using polycaprolactone three alcohol (PCL3091) as core, isocyanate (IPDI), sulfonated polyester diol (BY3301) and pentaerythritol three acrylates (PETA) as raw material, arm shaped sulfonic acid type polyurethane oligomers were prepared. Two kinds of oligomers were copolymerized with acrylic monomers to prepare silicone modified crosslinking polyurethane acrylate emulsion. The structure and properties of polymer were characterized by FT-IR, SEM, TG and water contact angle measurement; and effects of the Props-SH contents on the water resistance, mechanical properties and thermal properties of the film were studied. The results show that when the PropS-SH mass fraction is 8%, the emulsion particle size is averaged at 117 nm, the surface of the film has obvious protruding phenomenon and the glossiness is 37°±1.2°; the film absorption rate is 5.1%±0.2% and the water contact angle is 105.6°±0.5°, the comprehensive performance of the film is the best, the tensile strength is (19.1±0.4) MPa, and the shore hardness is (51±0.6) HA, the decomposition temperatures at 10% and 50% mass loss are 306.9 ℃ and 386.0 ℃ respectively, and the water resistance and heat resistance are improved significantly compared with the unmodified film.