基于双核咪唑盐阴离子交换膜的制备与表征
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(21476031);江苏省自然科学基金资助项目(BK20151187);江苏省高等学校自然科学研究重大项目(18KJA430004,17KJA430002)


Synthesis and Characterization of Anion Exchange Membrane Based on Binuclear Imidazolium Salt
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用两步法合成了双核溴化1-乙烯基-3-(6-(1-丁基咪唑))己基咪唑盐[VBImHIm][Br]2,并通过1H-NMR对[VBImHIm][Br]2的化学结构进行了表征;然后将[VBImHIm][Br]2与苯乙烯、丙烯腈混合均匀后,通过紫外光引发聚合,得到碱性阴离子交换膜。通过傅里叶变换红外光谱对阴离子交换膜的结构进行了表征,并系统对膜的吸水率、溶胀度、热稳定性、力学性能及电导率等进行了研究。研究结果表明,该类阴离子交换膜降解温度达到300 ℃,[VBImHIm][Br]2含量为10%的阴离子交换膜25 ℃时的吸水率为96%,溶胀度只有44%,拉伸强度为38.32 MPa,最大断裂伸长率可达26.37%;在80 ℃时,其离子的电导率可达22 mS/cm,该类阴离子交换膜有望应用于碱性阴离子交换膜燃料电池领域。

    Abstract:

    Binuclear imidazolium salt, 1-vinyl-3-(6-(1-butylated imidazole)) hexyl imidazole ([VBImHIm][Br]2), was synthesized and the chemical structure of [VBImHIm][Br]2 was characterized by 1H-NMR. Alkaline anion-exchange membranes (AEMs) based on [VBImHIm][Br]2 were prepared by irradiation with UV light. The structure of the membranes was characterized by FT-IR, and the water uptake, swelling degree, thermal stability, mechanical properties and conductivity of the membranes were systematically studied. These AEMs are thermally stable up to 300 ℃, the AEM with 10wt% [VBImHIm][Br]2 exhibits a high water uptake of 96% and swelling degree of 44% at 25 ℃. The tensile strength and the elongation at breaks of [VBImHIm][Br]2-10 are 38.32 MPa and 26.37%, respectively and its ionic conductivity is up to 22 mS/cm at 80 ℃. All of these results indicate good potential applications in alkaline anion exchange membrane fuel cells.

    参考文献
    相似文献
    引证文献
引用本文

袁文森,李杏杏,祝缓缓,储富强,袁宁一,丁建宁,林本才.基于双核咪唑盐阴离子交换膜的制备与表征[J].高分子材料科学与工程,2019,35(1):35-40. Wensen Yuan, Xingxing Li, Huanhuan Zhu, Fuqiang Chu, Ningyi Yuan, Jianning Ding, Bencai Lin. Synthesis and Characterization of Anion Exchange Membrane Based on Binuclear Imidazolium Salt[J]. Polymer Materials Science & Engineering,2019,35(1):35-40.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-02-13
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司