马来酸酐接枝改性稀土异戊橡胶的制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation and Properties of Maleated Rare Earth Isoprene Rubber
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用溶液法,在稀土异戊橡胶(IR)聚合反应后,加入马来酸酐进行非均相溶液接枝改性,制备了马来酸酐接枝异戊橡胶(IR-g-MAH)。通过傅里叶变换红外光谱测试,证实改性后马来酸酐单体接枝在IR大分子链上。实验研究接枝率对IR-g-MAH生胶性能和硫化胶性能的影响,结果表明,与IR相比,IR-g-MAH具有较好的生胶塑性和较高的门尼黏度;马来酸酐接枝率小于1%时,硫化胶的定伸应力明显优于IR,接枝率为0.61%时最高,100%和300%定伸应力分别为3.2 MPa和13.4 MPa。

    Abstract:

    Maleated isoprene rubber (IR-g-MAH) was prepared by blending maleic anhydride (MA) to isoprene rubber (IR) compounds catalyzed by the rare earth catalysts after finish polymerization reaction. The measurement results of FT-IR confirm that the MA monomer is grafted onto the IR macromolecular chain. The effects of the grafting ratio of maleic anhydride on properties of the raw rubber and the vulcanized rubber were studied. The results show that IR-g-MAH has better green plasticity and higher Mooney viscosity. When the grafting ratio is less than 1%, the tensile modulus of IR-g-MAH vulcanizates is better than that of IR. When the grafting ratio is 0.61%, the tensile modulus of IR-g-MAH vulcanizates is the highest,and the 100% and 300% modulus are 3.2 MPa and 13.4 MPa respectively.

    参考文献
    相似文献
    引证文献
引用本文

何丽霞.马来酸酐接枝改性稀土异戊橡胶的制备及性能[J].高分子材料科学与工程,2019,35(2):165-170. Lixia He. Preparation and Properties of Maleated Rare Earth Isoprene Rubber[J]. Polymer Materials Science & Engineering,2019,35(2):165-170.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-03-07
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司