AlEt1.5Cl1.5与Al(OPhCH3)(iBu)2复配对钼系催化丁二烯聚合和产物微观结构的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

山东省自然科学基金资助项目(ZR2016EMM03)


Effect of Compounding of AlEt1.5Cl1.5 and Al(OPhCH3)(i-Bu)2 on Polymerization Reactivity of Butadiene Catalyzed by Mo-Based Catalyst and Microstructure of Products
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用MoCl5·磷酸三丁酯(TBP)/Al(OPhCH3)(i-Bu)2和MoCl5·TBP/AlEt1.5Cl1.5钼系催化体系催化丁二烯(Bd)配位聚合可分别制备高1,2含量的聚丁二烯橡胶(HVPB)和含反式(trans)-1,4-结构的部分结晶的聚丁二烯橡胶。在同一反应器中先加入Al(i-Bu)2(OPhCH3)/MoCl5·TBP催化丁二烯聚合,然后单独加入AlEt1.5Cl1.5或同时加入AlEt1.5Cl1.5/MoCl5·TBP,制备1,2-结构和trans-1,4结构在一定范围内可调的聚丁二烯的立构共混物。文中研究了催化剂的加入方式、第二组分加入时间和聚合温度等对聚合活性和产物结构的影响。实验结果表明,通过2种Al加入量的调节和反应条件的改变可实现1,2-结构含量和trans-1,4-结构含量分别在30%~80%和15%~60%范围内的调节,从而制得含一定结晶微区的无定形1,2-PB,有望提高1,2-PB的力学强度。

    Abstract:

    Polybutadiene rubbers with high 1,2-structure contents (HVBR) and partially crystallized trans-1,4 structures were prepared by the coordination polymerization of butadiene (Bd) catalyzed by two types of catalyst systems of MoCl5·tributyl phosphate (TBP)/ Al(OPhCH3)(i-Bu)2 and MoCl5·TBP/ AlEt1.5Cl1.5, respectively. The Al(i-Bu)2(OPhCH3)/MoCl5·TBP catalyst system was firstly added into the reactor to initiate the polymerization of butadiene, and then AlEt1.5Cl1.5 was added alone or AlEt1.5Cl1.5/MoCl5·TBP was joined at the same time to prepare the polymerization blends, of which 1,2-struceres and trans-1,4 structures could be adjusted at a certain range. The effects of the adding way of catalyst, adding time of second components and reaction temperature on the polymerization reactivity and microstructures were investigated. The experimental results show that the contents of 1,2-structure and trans-1,4-structure could be adjusted from 30% to 80% and from 15% to 60% through control of the adding amounts of two kinds of Al and reaction conditions, which is beneficial to prepare amorphous 1,2- polybutadiene (1,2-PB) with a certain crystalline region and is expected to improve the tensile strength of 1,2-PB.

    参考文献
    相似文献
    引证文献
引用本文

张彬彬,李培培,赵 煊,华 静. AlEt1.5Cl1.5与Al(OPhCH3)(iBu)2复配对钼系催化丁二烯聚合和产物微观结构的影响[J].高分子材料科学与工程,2019,35(3):8-13. Binbin Zhang, Peipei Li, Xuan Zhao, Jing Hua. Effect of Compounding of AlEt1.5Cl1.5 and Al(OPhCH3)(i-Bu)2 on Polymerization Reactivity of Butadiene Catalyzed by Mo-Based Catalyst and Microstructure of Products[J]. Polymer Materials Science & Engineering,2019,35(3):8-13.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-04-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司