聚乙二醇含量对聚乳酸/聚丁二酸丁二醇酯合金结构与性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

湖北工业大学大学生创新创业训练计划项目(201710500053);湖北省自然科学基金资助项目(2017CFB284);湖北省教育厅青年人才项目(Q20171409);国家自然科学基金资助项目(51703054)


Effects of Polyethylene Glycol Contents on Microstructure and Properties of Polylactic Acid/Polybutylene Succinate Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过熔融共混制备了聚乳酸/聚丁二酸丁二醇酯/聚乙二醇(PLA/PBS/PEG)三相共混物,利用扫描电子显微镜、平板流变仪、差示扫描量热仪、动态力学热分析仪、万能拉力试验机和简支梁冲击试验机分别研究了PEG含量对PLA/PBS(80/20)合金微观结构与性能的影响。结果表明,添加PEG组分能够降低PBS分散相的尺寸、均化尺寸分布、增加界面层厚度;随着PEG含量增加,PLA/PBS/PEG共混物复数黏度降低并且剪切变稀行为更加显著,共混物中PLA组分的玻璃化转变温度和冷结晶温度降低幅度随着PEG含量增加而增大,同时结晶度增加。动态力学热分析曲线显示PLA与PBS组分的玻璃化转变温度相互靠近,说明PEG能够促进PLA与PBS的相容性。力学性能结果表明,添加PEG组分到PLA/PBS(80/20)共混物中,可以在拉伸强度降低幅度不大的情况下大幅度提高共混体系的韧性。

    Abstract:

    Polylactic acid/polybutylene succinate/polyethylene glycol(PLA/PBS/PEG) triple-phase blends were prepared by melt blending. And effects of PEG contents on the microstructure and properties of PLA/PBS (80/20) blends were investigated by SEM, rotational rheometer, differential scanning calorimeter(DSC), dynamic thermomechanical analyzer(DMA), universal tensile tester and Charpy impact tester, respectively. The results show that the addition of PEG can reduce the size and homogenize size distribution of the dispersed phase, increase the thickness of the interface layer. With the increase of PEG content, the complex viscosity of PLA/PBS/PEG blends decreases and the shear thinning behavior becomes more significant. Furthermore, the declining degree of glass transition temperature and cold crystallization temperature of the PLA component increases with the increase of PEG content, meanwhile, the crystallinity of blends increase. The DMA curves show that the glass transition temperatures of PLA and PBS components are close to each other, indicating that PEG could promote the compatibility of PLA with PBS. The results of mechanical properties show that the addition of PEG component to PLA/PBS (80/20) blends could remarkably improve the toughness of the blends while the tensile strength is reduced gently.

    参考文献
    相似文献
    引证文献
引用本文

杨永潮,李翔宇,张清清,夏承皓,杨前程,余 鹏.聚乙二醇含量对聚乳酸/聚丁二酸丁二醇酯合金结构与性能的影响[J].高分子材料科学与工程,2019,35(3):73-78. Yongchao Yang, Xiangyu Li, Qingqing Zhang, Chenghao Xia, Qiancheng Yang, Peng Yu. Effects of Polyethylene Glycol Contents on Microstructure and Properties of Polylactic Acid/Polybutylene Succinate Blends[J]. Polymer Materials Science & Engineering,2019,35(3):73-78.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-04-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司