芳纶短纤维的改性浸胶预处理对填充的三元乙丙橡胶材料性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金地区科学基金资助项目(51763004)


Influence of Impregnating Latex Pretreatment of Short Aramid Fibers on Properties of Filled EPDM Rubber Materials
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    芳纶短纤维(AF)因具有高模量、耐高温以及耐化学稳定性等优异性能而得到广泛应用。然而,AF表面高度结晶且呈化学惰性导致制备的复合材料界面黏接较差,难以充分利用其优异性能。文中首先对AF进行热氧化处理,再使用CaCl2乙醇溶液进行处理,最后用极性的丁吡胶乳浸渍处理得到改性浸胶预处理AF,重点研究了不同改性预处理方法对AF填充的三元乙丙橡胶(EPDM)界面黏合性能的影响。实验结果表明,AF经复合处理后所制备的复合材料性能提高显著,其100%定伸应力、横向撕裂强度和纵向撕裂强度比未改性AF制备的复合材料分别提高了50.00%、78.95%和52.35%,相对滑脱能提高205.83%。动态力学热分析仪(DMA)和扫描电镜(SEM)结果表明,复合处理AF制备的复合材料纤维与橡胶界面黏接最好。

    Abstract:

    Aramid fibers (AF) were widely used owing to its high modulus and strength, outstanding temperature resistance and chemical stability. However, the highly crystallinity and low active surface of AF leaded to the poor interfacial adhesion performance of preparing composites, outstanding performances of AF have not been fully utilized. In this paper, AF was firstly treated by thermal oxidation treatment and then treated with calcium chloride-ethanol solution; finally, the pre-treated AF was impregnated with polar butadiene vinyl-pyridine rubber latex. The influences of different modified pretreatment methods on interfacial adhesion properties of AF filled ethylene propylene diene monomer (EPDM) were investigated. The results show that EPDM which is reinforced with AF prepared by complex processing has the most significant improvement in performances, the stretching stress at 100%, lateral tear strength and longitudinal tear strength compared with composites prepared by untreated AF are increased by 50.00%, 78.95% and 52.35%, respectively. The relative slip energy increases by 205.83%. Dynamic thermal mechanical analyzer (DMA) and SEM results show that the composites prepared by complex processing AF have the best adhesion with the rubber matrix.

    参考文献
    相似文献
    引证文献
引用本文

李 鹏,罗 筑,钟金成,周宗淘,刘春利.芳纶短纤维的改性浸胶预处理对填充的三元乙丙橡胶材料性能的影响[J].高分子材料科学与工程,2019,35(4):40-46. Peng Li, Zhu Luo, Jincheng Zhong, Zongtao Zhou, Chunli Liu. Influence of Impregnating Latex Pretreatment of Short Aramid Fibers on Properties of Filled EPDM Rubber Materials[J]. Polymer Materials Science & Engineering,2019,35(4):40-46.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-05-10
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司