Abstract:In this paper, three kinds of conducting chitosan-graft-polyaniline were successfully prepared in order to improve the processability of polyaniline (PANI). Chitosan was grafted with polyaniline through oxidative-radical copolymerization using ammonium persulfate in acidic medium. And three acids (octanoic acid, dodecanoic acid and perfluorooctanoic acid) were used as dopant. The processability of PANI is successfully improved by grafting onto the chitosan and the electrical conductivity of PANI is maintained at 10-4~10-2 S/cm. Tafel polarization and electrochemical impedance spectroscopy show that the chitosan-graft-polyaniline has a good anticorrosion protection to A3 carbon steel exposed to 0.10 mol/L H2SO4 aqueous solution, and the anticorrosion efficiency of the chitosan-graft-polyaniline increases with increasing the hydrophobicity of the chitosan-graft-polyaniline. This is due to the hydrophobic conducting chitosan-graft-polyaniline coating inhibited water from being absorbed by the coating, thus preventing corrosive chemicals and corrosion products from diffusing through the coatings. The perfluorooctanoic acid doped chitosan-graft-polyaniline has the highestest hydrophobicity with a contact angle of 142° and the anticorrosion efficiency of 70.75%. The grafting of PANI onto the chitosan molecules is confirmed by Fourier transform infrared spectroscopy (FT-IR) and 1H-nuclear magnetic resonance 1H-NMR) spectroscopy. As FT-IR shown, grafted polymers has not only the characteristic peaks of chitosan and polyaniline, but also peak shift phenomenona which is affected by the space effect after grafting. Therefore, the relation between chitosan and polyaniline is not physical mixing but grafting.