非晶或结晶尼龙6共混改性热塑性聚氨酯的耐溶剂性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

上海市自然科学基金资助项目(15ZR1415300)


Solvent Resistance of Thermoplastic Polyurethane Modified by Amorphous or Crystallized Nylon 6 Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用机械共混法分别制备了非晶尼龙6(Amorphous-PA6)/热塑性聚氨酯(TPU)与一般结晶的尼龙6(Crystalline-PA6)/TPU2种塑料合金,分析了尼龙6的非晶与结晶结构及共混比对塑料合金的耐热、抗拉和耐溶剂性能的影响。随着A-PA6含量增大,A-PA6/TPU 合金的耐热、抗拉和耐溶剂性能均逐渐提高,当A-PA6含量分别为10%和25%时,拉伸强度从纯TPU 的35.0MPa增至40.9MPa和43.9MPa,断裂伸长率基本不变,天那水浸泡6h的溶胀率比纯TPU降低达到14%,拉伸强度从纯TPU 的18.8 MPa提高到26.8 MPa和35.1 MPa,后者比纯TPU 增高86.7%,而与纯TPU 浸泡前相当。C-PA6/TPU 合金的C-PA6最佳含量为10%,天那水浸泡6h后拉伸强度从浸泡前的37.6 MPa降至23.0MPa,其抗拉和耐溶剂性能均低于A-PA6/TPU。

    Abstract:

    The two kinds of plastic alloy of amorphous nylon 6(A-PA6)/thermoplastic polyurethane (TPU) and crystalline nylon 6(C-PA6)/TPU were prepared by mechanical blending, respectively, and effects of the amorphous and crystalline structures of nylon 6 and blending-ratios on the heat-resistant, tensile strength and solvent resistance were analyzed. With the increase of A-PA6 content, the heat resistance, tensile strength and solvent resistance of A-PA6/TPU are gradually improved. When the A-PA6 contents are 10% and 25%, the tensile strength is increased from 35.0 MPa of pure TPU to 40.9 MPa and 43.9 MPa, and the elongation at break is basically unchanged, and the swelling rate of immersion for 6 h in Tianna water is decreased by 14% than that of pure TPU, and its tensile strength is increased from 18.8 MPa of pure TPU to 26.8 MPa and 35.1 MPa, the latter is 86.7% higher than that of pure TPU and is comparable to that of the pure TPU before soaking. The optimum content of C-PA6 for C-PA6/TPU is 10%, and after soaking for 6 h in Tianna water, its tensile strength is reduced from 37.6 MPa to 23.0 MPa, but its tensile and solvent resistances are still lower than those of A-PA6 /TPU.

    参考文献
    相似文献
    引证文献
引用本文

张 龙,郭 强,毕宸洋,曹志强,靳海童,杨奇轩.非晶或结晶尼龙6共混改性热塑性聚氨酯的耐溶剂性能[J].高分子材料科学与工程,2019,35(5):71-75. Long Zhang, Qiang Guo, Chenyang Bi, Zhiqiang Cao, Haitong Jin, Qixuan Yang. Solvent Resistance of Thermoplastic Polyurethane Modified by Amorphous or Crystallized Nylon 6 Blends[J]. Polymer Materials Science & Engineering,2019,35(5):71-75.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-07-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司