具有疏水表面的高强度再生纤维素复合薄膜的制备与微观结构
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金(51673135,51822305,51803140,21776186);四川省杰出青年基金(2017JQ0017)


Preparation and Microstructure of High Strength Regenerated Cellulose Composite Films with Hydrophobic Surface
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    将纤维素纳米晶(CNCs)混入纤维素溶液中,经过凝胶化再生制得具有疏水表面的高强度再生纤维素复合薄膜。扫描电镜表明CNCs与再生纤维素基体具有良好的相容性。X射线衍射研究发现CNCs的加入使复合薄膜纤维素I型晶含量提高。表面水接触角测试表明CNCs会提高复合薄膜表面亲水性,经过硅烷化改性之后复合薄膜表面呈疏水性,其水接触角约为105°。CNCs的加入使复合薄膜的拉伸强度达到92.0MPa,相比于纯再生纤维素薄膜(62.7 MPa)提升了46.7%。弹性模量也从3466MPa提高至6025MPa,提升了约1.6倍。CNCs的加入能提高再生纤维素薄膜起始热降解温度和热降解峰值温度。

    Abstract:

    High strength regenerated cellulose composite films with hydrophobic surface were prepared after the gelation regeneration of mixture of cellulose nanocrystals and cellulose matrix. The structures of the composite films were studied by SEM. It is found that the CNCs have a good compatibility with the regenerated cellulose matrix. It is also found that the addition of CNCs increases the content of cellulose crystal of the composite films by XRD. The surface water contact angle test shows that the addition of CNCs enhances the surface hydrophilicity of the composite films. After silylation modification, the surface of the composite films is hydrophobic, and its water contact angle is about 105°. The addition of CNCs results in the tensile strength of regenerated cellulose films of 92.0 MPa, which is 46.7% higher than that of the pure regenerated cellulose film (62.7 MPa). Elastic modulus also increases from 3466 MPa to 6025 MPa, an increase of about 1.6 times. The thermally degrade beginning temperature and the maximum mass loss rate temperature are increased by adding CNCs.

    参考文献
    相似文献
    引证文献
引用本文

杨 彪,李 磊,周子涵,徐 玲,钟淦基,李忠明.具有疏水表面的高强度再生纤维素复合薄膜的制备与微观结构[J].高分子材料科学与工程,2019,35(5):157-163. Biao Yang, Lei Li, Zihan Zhou, Ling Xu, Ganji Zhong, Zhongming Li. Preparation and Microstructure of High Strength Regenerated Cellulose Composite Films with Hydrophobic Surface[J]. Polymer Materials Science & Engineering,2019,35(5):157-163.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-07-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司