Abstract:The polysulfide rubber was terminal- modified by amino, which was introduced into polysulfide rubber to enhance its active hydrogen content. The modified epoxy resin was obtained by mixing different ratios of amino terminated polysulfide rubber with epoxy resin. The structure of the modified epoxy resin was analyzed by Fourier transform infrared spectroscopy. Dynamic mechanical properties of the modified epoxy resin were measured by dynamic thermal mechanical analyzer. The tensile strength, breaking elongation and hardness of the modified epoxy resin were measured by tension machine and hardness tester. The volume of the cured epoxy resin before and after curing was recorded to get the contraction rate. The results show that the amino is introduced into the polysulfide rubber and the active hydrogen in the amino terminated polysulfide rubber reacts with the epoxy resin. The ring of epoxy group is opened, the polysulfide rubber modified epoxy resin is formed, and the polysulfide rubber as soft segment play a toughening effect. In the curing system, the degree of crosslinking increases with the increase of mole ratio of active hydrogen and epoxy from 0.3 to 1.0. The content of polysulfide rubber as flexible segment increases, the elongation at break increases gradually from 5% to 17%, and the component of anionic polymerized epoxy resin as hard segment decreases. The tensile strength of cured product decreases gradually from 16.8 MPa to 5.2 MPa, and the hardness of Shore A decreases from 99 to 84.