相容剂对尼龙6/乙烯-辛烯嵌段共聚物共混体系结构与性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51721091)


Effect of Compatibilizer on Structure and Properties of Nylon 6/Ethylene-Octene Block Copolymer Blends
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    利用双螺杆挤出机将尼龙6(PA6)与乙烯-辛烯嵌段共聚物(OBC)共混,研究了3种相容剂EVA-g-MAH-1(接枝率1%)、POE-g-MAH-0.6(接枝率0.6%)和POE-g-MAH-1(接枝率)1%及相容剂添加量对体系的结构与性能的影响。结果表明,当POE-g-MAH-0.6添加量高于2%,POE-g-MAH-1添加量高于3%时,共混物的缺口冲击强度大幅度提高。当相容剂为POE-g-MAH-0.6,添加量为5%时,冲击强度达83.0kJ/m2,比纯PA6提高了14倍。相容剂的加入对于共混物的强度影响不大。形态分析表明,加入高于2%的POE-g-MAH-0.6时,OBC分散相尺寸明显减小且界面相互作用增强;高冲击强度的样品中基体与弹性体发生了大量塑性变形。

    Abstract:

    Nylon 6 (PA6) was blended with ethylene-octene block copolymer (OBC) using a twin-screw extruder. Three different compatibilizers, including EVA-g-MAH-1 (grafting ratio 1%), POE-g-MAH-0.6 (grafting ratio 0.6%), POE-g-MAH-1 (grafting ratio 1%) were added, and the effects of the content of the compatibilizers on the structure and properties of the blends were studied. The results show that when the content of POE-g-MAH-0.6 is higher than 2%, and the content of POE-g-MAH-1 is higher than 3%, the notched impact strength of the blends is enhanced significantly. With 5% POE-g-MAH-0.6 as compatibilizer, the impact strength of the blends reaches 83.0 kJ/m2, 14 times higher than that of pure PA6. The addition of the compatibilizers show little effect on the strength of the blends. SEM results show that with the addition of 2% POE-g-MAH-0.6, the dispersed phase size of OBC is significantly reduced and the interfacial interaction is enhanced. The impact fractured surface morphology shows that the plastic matrix and the elastomer experience large plastic deformation during impact for the samples with high impact strength.

    参考文献
    相似文献
    引证文献
引用本文

付如斌,包睿莹,谢邦互,杨鸣波,杨 伟.相容剂对尼龙6/乙烯-辛烯嵌段共聚物共混体系结构与性能的影响[J].高分子材料科学与工程,2019,35(7):44-48. Rubin Fu, Ruiying Bao, Banghu Xie, Mingbo Yang, Wei Yang. Effect of Compatibilizer on Structure and Properties of Nylon 6/Ethylene-Octene Block Copolymer Blends[J]. Polymer Materials Science & Engineering,2019,35(7):44-48.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-08-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司