熔融共混制备PLA-g-MAH/EP对PLA/PBAT复合材料性能的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Effect of Melt Blending Preparation of PLA-g-MAH/EP on the Properties of PLA/PBAT Composites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以过氧化二异丙苯(DCP)为引发剂,马来酸酐(MAH)、环氧树脂(EP)为共同接枝单体,在转矩流变仪中通过熔融法制备聚乳酸(PLA)双接枝马来酸酐/环氧树脂(PLA-g-MAH/EP),以作为聚乳酸/聚己二酸-对苯二甲酸丁二酯(PBAT)复合材料的增容剂。使用双螺杆挤出机制备了PLA/PBAT 复合材料。结果表明,当MAH 含量为2%时,PLA-g-MAH 接枝率最大为0.48%。EP的加入使得PLA-g-MAH 接枝率获得极大地提升,当加入3%EP后,PLA-g-MAH(2%)-EP-3接枝物接枝率最大为1.81%。差示扫描量热分析结果表明添加PLA-g-MAH/EP接枝物作为增容剂后,复合材料的双重熔融峰消失。动态力学热分析曲线表明复合材料加入相容剂后的界面强度增加。力学性能测试发现,接枝物作为PLA/PBAT复合材料相容剂能有效地提升复合材料的拉伸强度和缺口冲击强度。同时扫描电镜图像显示,添加相容剂后PBAT在PLA基体相获得了有效分散,PLA与PBAT两相之间的相容性得到提高。

    Abstract:

    Polylactic acid (PLA) grafted with maleic anhydride/ epoxy resin (PLA-g-MAH/ EP), as compatibilizer for PLA/ polyadipic acid-butylene terephthalate (PBAT) composites, was prepared by the melt reactive method in a torque rheometer using dicumyl peroxide (DCP) as initiator, and maleic anhydride (MAH) as well as epoxy resin (EP) as co-graft monomer. The PLA/ PBAT composites were prepared by a twin screw extruder. The results show that the grafting rate of PLA-g-MAH is 0.48% when the content of MAH is 2%. The addition of EP greatly promotes the grafting rate of PLA-g-MAH and the grafting rate of PLA-g-MAH (2%)-EP is 1.81% after addition of 3% EP. DSC results show that the double melting peaks of composites disappeare after adding PLA-g-MAH/ EP as compatibilizer. After characterizing the mechanical properties for composites, PLA-g-MAH/EP is found as efficient compatibilizer for PLA/ PBAT composites to highly improve its tensile strength and notch impact strength. At the same time, SEM images show that when PLA-g-MAH/EP is applied, PBAT is effectively dispersed in the PLA matrix phase, which improves the compatibility between PLA and PBAT.

    参考文献
    相似文献
    引证文献
引用本文

谢丽锦,黄宏巍,杨 乐,张 丰,罗 筑.熔融共混制备PLA-g-MAH/EP对PLA/PBAT复合材料性能的影响[J].高分子材料科学与工程,2019,35(7):74-80. Lijin Xie, Hongwei Huang, Le Yang, Feng Zhang, Zhu Luo. Effect of Melt Blending Preparation of PLA-g-MAH/EP on the Properties of PLA/PBAT Composites[J]. Polymer Materials Science & Engineering,2019,35(7):74-80.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-08-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司