聚甲基苄基二烯丙基氯化铵的制备及脱色性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金青年基金资助项目(51503100)


Preparation and Decolorization Performance of Poly- N,N-Diallyl- N-Methyl-Benzylammonium Chloride
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过水溶液聚合法,采用引发剂一次性加入三阶段升温工艺,以甲基苄基二烯丙基氯化铵(DAMBAC)为单体,偶氮二异丁脒盐酸盐(V-50)为引发剂,乙二胺四乙酸四钠盐(Na4EDTA)为金属离子络合剂,对聚甲基苄基二烯丙基氯化铵(PDAMBAC)制备工艺条件采用响应曲面优化法(RSM),得到聚合物最佳制备条件为:w(DAMBAC)=82.5%,m(V-50)∶m(DAMBAC)=3.03%,m(Na4EDTA)∶m(DAMBAC)=0.0147%,T1=61.8 ℃,T2=70.6 ℃和T3=85.0 ℃,各阶段均反应3 h。在实验范围内,各因素的影响顺序分别为T1>T2>T3、w(DAMBAC)>m(V-50)∶m(DAMBAC)>m(Na4EDTA)∶m(DAMBAC),得到聚合物重均相对分子质量(Mw)最高值为7.86×104,单体转化率(Conv.)为90.85%。模拟活性染料废水脱色性能对比实验表明,以脱色率为考察指标,该聚合物对活性染料模拟废水的脱色效果明显优于传统的二烯丙基季铵盐均聚物——聚二甲基二烯丙基氯化铵,PDAMBAC对3种活性染料的脱色率均达到了96.00%以上,最佳投加量条件下对C.I.活性红3BF、C.I.活性蓝KN-R和C.I.活性黄3RF染料的脱色率分别为96.01%、97.21%和99.70%,分别比PDMDAAC的脱色率高9.14%、56.64%和10.42%。

    Abstract:

    Poly(N,N-diallyl-N-methyl-benzylammonium chloride) i.e. PDAMBAC was synthesized from N,N-diallyl-N-methyl-benzylammonium chloride i.e. DAMBAC as monomer, azobisisobutyl hydrazine hydrochloride(V-50)as initiator, ethylenediaminetetraacetic acid tetrasodium salt (Na4EDTA)as metal ion complexing agent by aqueous solution polymerization, and the initiator was added in a lump and three-stages heating process was adopted. In this paper, response surface methodology was utilized to optimize the polymer preparation conditions. The optimum preparation conditions are w(DAMBAC)=82.5%,m(V-50)∶m(DAMBAC)=3.03%, m(Na4EDTA)∶m(DAMBAC)=0.0147%,T1=61.8 ℃, T2=70.6 ℃ and T3=85.0 ℃, each heating stage lasts for 3 h. In this experiment, the influence order for each factor is T1>T2>T3 w(DAMBAC)>m(V-50)∶m(DAMBAC)>m(Na4EDTA)∶m(DAMBAC), and the maximum weight average molecular weight (Mw) of PDAMBAC is 7.86×104, corresponding monomer conversion rate (Conv.) is 90.85%. The comparison experiment of the decolorization performance of simulated reactive dye wastewater shows that the decolorization effect of the polymer is significantly better than the traditional diallyl quaternary ammonium salt——PDMDAAC based on the decolorization rate. The decolorization rate of PDAMBAC for all 3 reactive dyes reaches higher than 92.28%, among which the decolorization rates for CI Reactive Red 3BF, CI Reactive Blue KN-R and CI Reactive Yellow 3RF are 96.01%、97.21% and 99.70%, and which is 9.14%, 56.64% and 10.42% higher than those of PDMDAAC, respectively.

    参考文献
    相似文献
    引证文献
引用本文

孙运通,张秀娟,陶贤平,贾 旭,张跃军.聚甲基苄基二烯丙基氯化铵的制备及脱色性能[J].高分子材料科学与工程,2019,35(9):1-7. Yuntong Sun, Xiujuan Zhang, Xianping Tao, Xu Jia, Yuejun Zhang. Preparation and Decolorization Performance of Poly- N, N-Diallyl- N-Methyl-Benzylammonium Chloride[J]. Polymer Materials Science & Engineering,2019,35(9):1-7.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-12-03
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司