Abstract:In order to avoid environmental pollution caused by the use of organic solvents, a high concentration zinc chloride aqueous solution was used as solvent, acrylonitrile was initiated by an oxidation-reduction initiation system to obtain a polyacrylonitrile casting solution, and the polyacrylonitrile (PAN) filtration membrane was prepared by using water as coagulation bath, which was recorded as PAN (ZnCl2) membrane. At the same time, PAN filtration membranes were also prepared by using dimethylformamide (DMF) as organic solvent, commercial PAN as raw material and water as coagulation bath, and the membrane was recorded as PAN (DMF) membrane. The morphology of the two membranes was characterized by SEM and XRD. The mechanical properties, hydrophilicity, anti-contamination, and filtration properties of the two dyes of the two membranes were investigated. Results show that PAN (ZnCl2) membranes have higher hydrophilicity, pollution resistance and mechanical properties than PAN (DMF) membranes. Under the pressure of 0.1 MPa, the water flux of PAN(ZnCl2) membrane reaches 70 L/(m2·h), the flux of dye aqueous solution is 50~65 L/(m2·h), the membrane has anti-dye pollution performance. The retention rates of PAN(ZnCl2) membrane for Congo red (Mw=696.68), Direct Yellow 27 (Mw=662.62) and Amaranth (Mw=604.47) are 100%, 100% and 55%, respectively. Although the water flux of PAN (DMF) membrane reaches 150 L/(m2·h), its retention rates for Congo red, direct yellow 27 and amaranth are only 92%, 68% and 19%, respectively, and PAN (DMF) is easily contaminated by the dyes.