填充油组成对充油SEBS体系力学性能、热性能及微观结构的影响
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

四川大学中石油克拉玛依石化有限责任公司项目(17H0764)


Influence of Rubber Oil Composition on Mechanical and Thermal Properties, Microphase Structure of Oil-Extended SEBS
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    自制了一系列运动黏度基本保持不变、组成有规律连续变化的填充油,首次系统研究了油品组成对充油聚苯乙烯-乙烯/丁烯-苯乙烯(SEBS)体系结构与性能的影响,分析了油品在多相的SEBS中的相平衡和“再分配”规律,揭示了油品组成对充油体系结构与性能的影响机制。研究发现,随着油品中环氧油含量(CN)的增加(由27.4%到50.4%),动态力学热分析显示TgPS由108.6 ℃降至98.03 ℃,小角X射线散射结果显示软硬相电子密度差逐渐降低,表明环烷烃分子进入软硬相之间,增塑聚苯乙烯(PS)相与其产生相互作用,充油体系起始剪切黏度由9361.30 Pa·s降至4562.71Pa·s,流动性显著增大;PS相间距由38.929 nm增至40.329 nm,油分子逸出通道加宽,迁出率增大(由0.266%增至2.858%),体系热失重性能降低Tonset由289.0 ℃降至241.7 ℃)。在CN为33.2%时,充油SEBS的拉伸强度达到极大值(11.62 MPa),而伸长率随CN变化基本保持不变(1000%左右)。

    Abstract:

    A series of oils with the same kinematic viscosity while continuous changing compositions were developed, and the effect of different oil compositions and properties on the oil multiple phase equilibrium and “redistribution” rule in SEBS was systematically studied for the first time. An integral influencing mechanism of oil composition on the structure and properties of SEBS/PP/oil blends was put forward. With increasing oil CN contents (from 27.4% to 50.4%), DMA result shows that Tg,PSdrops form 108.6 ℃ to 98.03 ℃, and SAXS result shows the electron density difference between the soft and hard phases reduces gradually, indicating that naphthenic oil (NO) enters the interphase between the soft and hard phases. The crosslinking point PS phase is plasticized and softened by NO, the initial shear rate drops from 9361.30 Pa·s to 4562.71 Pa·s, the flowability increases prominently. SAXS also shows that the distance between the PS phase is enlarged from 38.929 nm to 40.329 nm, widened the escape channels for oil molecules and leading to an increase in oil migration and a drop in thermal mass loss property. The maximum of the tensile strength (11.62 MPa) is reached under the CN content of 33.2%, the elongation at break keeps unchanged (around 1000%) with the changing CN.

    参考文献
    相似文献
    引证文献
引用本文

史晓滔,辛秀婷,谢海生,教 震,吴 芮,熊春珠,张爱民,武建勋.填充油组成对充油SEBS体系力学性能、热性能及微观结构的影响[J].高分子材料科学与工程,2019,35(10):108-114. Xiaotao Shi, Xiuting Xin, Haisheng Xie, Zhen Jiao, Rui Wu, Chunzhu Xiong, Aimin Zhang, Jianxun Wu. Influence of Rubber Oil Composition on Mechanical and Thermal Properties, Microphase Structure of Oil-Extended SEBS[J]. Polymer Materials Science & Engineering,2019,35(10):108-114.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-12-03
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司