阳离子型水基疏水涂料的制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation and Properties of Aqueous Cationic Hydrophobic Coatings
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过可逆加成-断裂链转移聚合(RAFT)合成了聚(丙烯酸二甲氨基乙酯-co-苯乙烯)-b-聚丙烯酸六氟丁酯嵌段共聚物(P(DMAEA-co-St)-b-PHFBA),并以此制备了阳离子型水基疏水涂料。通过凝胶渗透色谱、核磁共振氢谱、接触角等对P(DMAEA-co-St)-b-PHFBA结构及性能进行了研究,探讨了分散介质、烘干温度、纳米二氧化硅粒径及用量对涂料接触角的影响;最后研究了涂料漆膜性能。结果表明,通过RAFT聚合法成功合成了P(DMAEA-co-St)-b-PHFBA,经酸化后,可得阳离子水分散体,薄膜对水接触角为103°。将P(DMAEA-co-St)-b-PHFBA与粒径200 nm的SiO2以质量比1/1混合后,接触角可达153°(8 μL)。将上述疏水纳米颗粒与乙烯-醋酸乙烯共聚物乳液(VAE)混合后,可得综合性能优异的阳离子疏水涂料。当P(DMAEA-co-St)-b-PHFBA/SiO2复合物与VAE质量比为1/1时,接触角为133°(8 μL),铅笔硬度为HB,附着力为1级,耐冲击性能为50 cm。

    Abstract:

    Poly(dimethylaminoethyl acrylate-co-styrene)-b-polyhexafluorobutyl acrylate block copolymer(P(DMAEA-co-St)-b-PHFBA) was synthesized by reversible addition-fragmentation chain transfer radical polymerization (RAFT). And an aqueous cationic hydrophobic coating was prepared using this block copolymer. The structure and properties of P(DMAEA-co-St)-b-PHFBA were investigated by gel permeation chromatography (GPC), nuclear magnetic resonance (1H-NMR) and contact angle (WCA). The effects of dispersion medium, dry temperature, particle sizes and amounts of nano-silicon dioxide on contact angles of hydrophobic coatings were studied. Finally, the performances of aqueous cationic hydrophobic coatings were studied. The results show that P(DMAEA-co-St)-b-PHFBA block copolymers were successfully synthesized by RAFT. After acidification, the copolymer could be well-dispersed in water, and the contact angle of the coating to water could reach 103°. When P(DMAEA-co-St)-b-PHFBA was mixed with 200 nm SiO2 at a mass ratio of 1/1, the contact angle of the coating could be increased to 153° measured by 8 μL water droplet, but the performance of the coating is poor. The performance of the coating can be greatly improved by introducing ethylene-vinyl acetate copolymer (VAE) emulsion into the aqueous cationic hydrophobic coating. When the mass ratio of P(DMAEA-co-St)-b-PHFBA/SiO2 to VAE emulsion is 1/1, the contact angle of the coating reaches 133° measured by the water droplet of 8 μL. And the coatings with the pencil hardness of HB, the adhesion level of 1 grade, and the impact strength of 50 cm can be obtained.

    参考文献
    相似文献
    引证文献
引用本文

刘 佳,李 坚,任 强,汪称意.阳离子型水基疏水涂料的制备及性能[J].高分子材料科学与工程,2019,35(11):8-16. Jia Liu, Jian Li, Qiang Ren, Chengyi Wang. Preparation and Properties of Aqueous Cationic Hydrophobic Coatings[J]. Polymer Materials Science & Engineering,2019,35(11):8-16.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2019-12-23
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司