笼型聚倍半硅氧烷增韧3层聚酰亚胺薄膜的制备与性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

2014年前沿与关键技术创新项目(2014B090916001)


Preparation and Properties of Three-Layer Polyimide Films Toughened by Polyhedral Oligomeric Silsesquioxane
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以3,3′,4,4′-联苯四酸二酐(BPDA)-对苯二胺(PDA)/4,4′-二苯醚二胺(ODA)型聚酰亚胺为芯层,将2,2′-双(4-(4-氨基苯氧基)苯基)丙烷(BAPP)-BPDA型聚酰胺酸涂覆于芯层的上、下表面并热亚胺化得到3层聚酰亚胺薄膜。为提高3层聚酰亚胺薄膜的韧性,将降冰片烯二酸酐-马来酰亚胺基七异丁基聚倍半硅氧烷交替共聚物(poly(MIPOSS-alt-NA))作为BPDA的共单体引入到上、下表层的热塑性聚酰亚胺中。结果表明,当poly(MIPOSS-alt-NA)的质量分数为6.0%时,3层聚酰亚胺薄膜的断裂伸长率从7.2%提高到14.5%,热膨胀系数则从27.0×10-6K-1降低至23.6×10-6K-1,与铜箔制备的柔性覆铜板剥离强度达到12.0 N/cm,针对拉伸断面电镜照片的变化对增韧机理进行了分析。

    Abstract:

    A series of three-layer polyimide films with sandwich-like structure were prepared by coating polyamic acid onto both sides of middle-layer polyimide and further thermal imidization. The middle-layer polyimide came from the condensation of 3,3′,4,4′-biphenyltetracarboxylic dianhydride(BPDA) and p-phenylenediamine(PDA) /4,4′-oxydianiline(ODA), and the top and bottom layers were the thermoplastic polyimide made from the polymerization of BPDA and 2,2′-bis[4-(4-aminophenoxy)phenyl] propan(BAPP). In order to improve the toughness of three-layer polyimide films, poly(MIPOSS-alt-NA) was introduced into the top and bottom layers. It is found that the elongation at break of the three-layer polyimide film increases from 7.2% to 14.5% and the coefficient of thermal expansion (CTE) decreases from 27.0×10-6K-1 to 23.6×10-6K-1 with 6.0% poly(MIPOSS-alt-NA). Furthermore, the peel strength of flexible copper clad laminate (FCCL) made with the three-layer polyimide film achieves 12.0 N/cm. The toughening mechanism was investigated by SEM micrographs of tensile-fractured surface.

    参考文献
    相似文献
    引证文献
引用本文

周宇彬,刘述梅,陈植耿,赵建青.笼型聚倍半硅氧烷增韧3层聚酰亚胺薄膜的制备与性能[J].高分子材料科学与工程,2020,36(1):99-105. Yubin Zhou, Shumei Liu, Zhigeng Chen, Jianqing Zhao. Preparation and Properties of Three-Layer Polyimide Films Toughened by Polyhedral Oligomeric Silsesquioxane[J]. Polymer Materials Science & Engineering,2020,36(1):99-105.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2020-02-26
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司