Abstract:It is an attractive idea to remove and collect oil without adversely affecting the environment. In this paper, graphene oxide (GO) was dispersed in a 1,4-butanediol solution and successfully dispersed in the raw material of polyurethane sponges to prepare ultra-high performance polyurethane/portion reduced graphene oxide (PRGO/PU) sponges. The effect of GO addition on the structure and properties of PU/PRGO sponges was investigated. The structure of PU/PRGO sponge was analyzed by scanning electron microscope, contact angle tester, thermogravimetric analyzer and FT-IR. The results show that the PU/PRGO sponge has good hydrophobic and lipophilic properties, and can selectively adsorb water kerosene/water. Compared with the PU sponge, the pore wall structure of the PU/PRGO sponge is rougher, and the PRGO sheet layer is fixed on the pore wall of the PU composite sponge. The FT-IR absorption peaks of PU do not change, indicating that the formation of PRGO does not change the molecular structure of PU. The initial decomposition temperature of the PU/PRGO sponge is higher than that of the pure PU sponge. When no GO is added, the PU sponge has a water contact angle of 86.2° and an oil contact angle of 22.5°; when the GO content is 0.5%, the water contact angle of the PU/PRGO sponge is increased to 131.3°, and the oil contact angle is decreased to 0°; however, when the GO content is more than 0.5%, the water contact angle of the PU composite sponge is lowered, and the oil contact angle is almost unchanged. In the separation process of kerosene/water, the separation efficiency is about 80%.