Abstract:Two blends (HDPE/LLDPE and HDPE/ m-LLDPE) used for cable sheathing were prepared by melt blending. The sealing strength between HDPE/LLDPE, HDPE/m-LLDPE blends,MDPE and aluminum-plastic tape, as well as the mechanical properties, relaxation behavior and compatibility between the components of the blends were investigated. The results show that the HDPE/LLDPE (7∶3) blend has the highest heat strength (27.2 N/cm) with the aluminum plastic strip; in the molten state, the lgG′-lgω of HDPE/LLDPE deviates linearly in the low frequency region, and the relaxation index λ decreases first and increases with the increase of HDPE content, indicating that the molecular chain entanglement increases first and weakens then, presenting a heterogeneous system; HDPE/LLDPE blend only shows a melting peak, indicating good compatibility between the two components; due to the overlapping of molecular interfaces, HDPE/LLDPE (7∶3) which shows the lowest interfacial tension with EVA has the smaller dispersed phase size (2.74 nm) and the higher interfacial layer thickness (1.02 nm), indicating the best component compatibility. It can be seen that the use of a wide range of relatively inexpensive HDPE and LLDPE blends can be used to prepare cable sheathing materials instead of MDPE.