Abstract:PLA/PBS blends were prepared by using poly (butylene succinate) (PBS) and poly (lactic acid) (PLA) as dispersed phase and matrix, respectively. Then, the microinjection molding of prepared PLA/PBS blend was conducted. Combined with the rheological measurement and ANSYS Polyflow computer simulation, the effects of microinjection molding conditions, including injection speed and melt temperature, on the structure and properties of PLA/PBS blends were studied. The results show that the strong shear and stretch fields generated during microinjection molding process could realize the in-situ fibrillation of PBS in the PLA matrix, and the microinjection molding conditions have important influences on the morphology of the dispersed PBS fiber, the crystallization behavior of the PLA matrix and the mechanical properties of the blends. It is found that the increase of melt temperature is beneficial to wall slip effect, reduction in negative tensile effect in gate area and enhancement in melt flow stability, thus facilitating the in-situ fibrillation of PBS. However, the excessively high injection speed would destroy the fiber structure due to negative tension effect, which is not conducive to the in-situ fibrillation of PBS and hence the property improvement of blends. The in-situ formed PBS fiber structures and their induced-formation of PLA oriented crystal structures are beneficial to the improvement in the mechanical properties of the blends.