氨基硅氧烷交联聚酰亚胺/SiO2复合多孔膜的制备及表征
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation and Characterization of Aminosiloxane Cross-Linked Polyimide/SiO2 Composite Porous Film
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以聚酰亚胺(PI)为基体、正硅酸乙酯(TEOS)为硅源前驱体、氨基硅氧烷(APTES)为交联剂,采用溶胶凝胶法制备出低导热系数PI/SiO2复合多孔膜。利用X射线衍射仪、红外光谱、扫描电镜、热重分析仪、导热系数测试仪及电子万能拉伸试验机测试SiO2的加入对多孔膜结构与性能的影响。结果表明,PI/SiO2复合多孔膜具有较低的导热系数和较好的力学强度,交联剂和SiO2含量对材料的热性能与力学性能有较大的影响。交联剂氨基硅氧烷能提高SiO2与PI基体的结合和材料的力学强度,材料的导热系数随SiO2含量增加逐渐降低,拉伸强度和弹性模量均未出现低于PI基体的现象,当SiO2含量为30%时弹性模量为214.3 MPa,导热系数为0.043 W/(m·K)。

    Abstract:

    Polyimide/silica (PI/SiO2) composite porous films with lower thermal conductivity were prepared by sol-gel method with PI as matrix, TEOS as SiO2 precursor and APTES as crosslinking agent. The effects of SiO2 addition on the structure and performance of the porous films were tested by XRD, FT-IR, SEM, thermal gravimetric analyzer (TGA), thermal conductivity tester and electronic universal tensile tester. The results show that the PI/SiO2 composite porous films have lower thermal conductivity and better mechanical strength, and the crosslinking agent and SiO2 content have a greater impact on the thermal and mechanical properties of the materials. The cross-linking agent amino-siloxane improves the bonding between SiO2 and PI matrix and the mechanical strength of the materials. The thermal conductivity of the materials gradually decreases with the increase of SiO2 content, and the tensile strength and elastic modulus are not lower than PI matrix. When the SiO2 content is 30%, the elastic modulus is 214.3 MPa, and the thermal conductivity is 0.043 W/ (m·K).

    参考文献
    相似文献
    引证文献
引用本文

丁成成, 李瑞懿, 俞 娟, 王晓东, 黄 培.氨基硅氧烷交联聚酰亚胺/SiO2复合多孔膜的制备及表征[J].高分子材料科学与工程,2020,36(8):67-73. Chengcheng Ding, Ruiyi Li, Juan Yu, Xiaodong Wang, Pei Huang. Preparation and Characterization of Aminosiloxane Cross-Linked Polyimide/SiO2 Composite Porous Film[J]. Polymer Materials Science & Engineering,2020,36(8):67-73.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2020-10-22
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司