苯胺三聚体改性磺酸盐型水性环氧固化剂的制备及涂膜防腐性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

安徽省2018年度科技重大专项(18030901077);安徽省高校自然科学研究重点项目 (KJ2016A792)


Preparation and Anticorrosion Properties of Aniline Trimer Modified Sulfonate Waterborne Epoxy Curing Agent
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用化学氧化法制备了可溶性的苯胺三聚体(AT),再以AT、丁基缩水甘油醚(660a)、四乙烯五胺(TEPA)为原料反应得到AT和TEPA的单封端混合产物,将产物与氨基磺酸盐(PPS)混合后再与环氧树脂(E-51)反应合成苯胺三聚体改性磺酸盐型水性环氧固化剂,将合成的水性环氧固化剂与环氧树脂E-51混合制得水性环氧乳液。通过红外光谱、透射电镜和热失重等方法对材料进行测试表征,并采用极化曲线、交流阻抗谱和耐盐水性试验评价涂层的防腐效果。结果表明,当AT的含量为8%(AT占TEPA和AT总量摩尔分数)时,乳液平均粒径为140 nm,热失重在10%的分解温度为196 ℃,涂层在划叉耐盐水试验中96 h内没有出现起泡现象,通过计算腐蚀电流密度可知其缓蚀效率达到了98.6%,表现出优异的防腐性能。

    Abstract:

    Soluble aniline trimer (AT) was prepared by chemical oxidation method. Subsequently, an aniline trimer modified sulfonate waterborne epoxy curing agent was prepared using sulphamate(AT), epoxy resin(E-51) and the mixture of single terminated aniline trimer(AT-660a) and tetraethylenepentamine(TEPA-660a). The structure and properties of the polymer were characterized by FT-IR, TEM and TG; and anticorrosion effect of the coating was evaluated by the polarization curve, AC impedance spectroscopy and salt water resistance test. The results show that when the content of AT is 8% (AT accounts for the total molar fraction of TEPA and AT), the average particle size of the emulsion is 140 nm, the decomposition temperature at 10% mass loss is 196 ℃, no blister is found on the surface of the coating after 30 d cross scratch neutral salt spray test and the corrosion inhibition efficiency reaches 98.6%. The film shows good corrosion resistance.

    参考文献
    相似文献
    引证文献
引用本文

王思学, 杨建军, 曹忠富, 吴庆云, 陈春俊, 张建安, 吴明元, 刘久逸.苯胺三聚体改性磺酸盐型水性环氧固化剂的制备及涂膜防腐性能[J].高分子材料科学与工程,2020,36(9):115-123. Sixue Wang, Jianjun Yang, Zhongfu Cao, Qingyun Wu, Chunjun Chen, Jian’an Zhang, Mingyuan Wu, Jiuyi Liu. Preparation and Anticorrosion Properties of Aniline Trimer Modified Sulfonate Waterborne Epoxy Curing Agent[J]. Polymer Materials Science & Engineering,2020,36(9):115-123.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2020-11-13
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司