蓝光聚合交联超吸水高强水凝胶的制备及性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

浙江省自然科学基金资助项目(LY21E030019);浙江理工大学桐乡研究院博后基金资助项目(TYY202014)


Preparation and Properties of Superabsorbent and High-Strength Poly(acrylic acid) Hydrogel Based on Blue Light Initiated Photopolymerization
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为协调水凝胶吸水与强度两者间的矛盾,构建了适用于蓝光诱导自由基聚合交联反应的水凝胶前驱液体系,快速、安全地制备超吸水、高强度的水凝胶。文中以樟脑醌(CQ)/二苯基碘鎓六氟磷酸盐(DPI)为蓝光引发剂,5种典型水溶性活性单体,丙烯酸(AA)、丙烯酰胺(AM)、丙烯酸羟乙酯(HEA)、甲基丙烯酸羟乙酯(HEMA)、聚乙二醇二丙烯酸酯(PEGDA)配制水凝胶聚合前驱液,在467 nm蓝光LED辐照下制备水凝胶。通过光差示扫描量热系统(Photo-DSC)和光流变系统(Photo-rheology)监测前驱液蓝光聚合效率及实时凝胶性能,以水凝胶材料的吸水率为指标优选蓝光聚合(交联)工艺,并对其物理力学性能进行了评估。结果表明, AM(~90%)、HEA(~40%)体系表现出较高的双键转化率。双官能团单体PEGDA具有最高的储能模量(~1.9×105Pa)和最短的凝胶点时间(37 s),AA,HEMA体系难以形成稳定交联结构,但通过引入交联剂PEGDA能大幅提高凝胶强度、缩短凝胶化时间。含有强亲水性官能团的单体AA体系表现出最佳的吸水率,其聚合交联水凝胶最佳的超吸水配方(均为质量分数,下同)为:1.0% CQ,0.125%~0.25% DPI,0.25% PEGDA(Mn=1000),65%中和度(对AA),光照时间20 min,此时吸水率可达1097%,且经吸水溶胀后仍可保持其结构稳定性。该水凝胶同时具有较高的力学强度,在最佳吸水率配方条件下拉伸应力为约0.44 MPa,拉伸应变可达1040%。

    Abstract:

    In order to prepare a superabsorbent and high-strength hydrogel, a hydrogel precursor system suitable for the blue-light induced radical polymerization was established. Camphorquinone (CQ)/diphenyliodine hexafluorophosphate (DPI) was used as typical blue-light initiator. Five typical water-soluble monomers, acrylic acid (AA), acrylamide (AM), hydroxyethyl acrylate (HEA), hydroxyethyl methacrylate (HEMA) and polyethylene glycol diacrylate (PEGDA) were chosen to compose the hydrogel precursors. Hydrogels were prepared under 467 nm blue-light LED irradiation. The photopolymerization efficiency and gel properties of the precursors were tested by photo differential scanning calorimetry (photo-DSC) and photo-rheology equipped with a photo-calorimetric accessory. The results show that AM and HEA systems exhibit higher double bond conversion (~90% and ~40%). The self-crosslinking monomer PEGDA has the highest storage modulus G′(~1.9×105Pa) and the shortest gel point time (37 s), and AA and HEMA systems are difficult to form stable crosslinking structure. However, the introduction of the crosslinker PEGDA can greatly enhance the gel strength and shorten the gelation time. The monomer AA system with strong hydrophilic functional groups shows the highest water absorption. The optimum superabsorbent formulation of the poly (AA/SA) hydrogel is 1.0% CQ, 0.125%~0.25% DPI, 0.25% PEGDA (Mn=1000), 65% neutralization degree (for AA) and 20 min of illumination. At this time, the water absorption of poly(AA/SA) hydrogel is about 1097%, and its structure stability can be maintained after swelling. The hydrogel also has a high mechanical strength. Under the optimum water absorption formula, the tensile stress is about 0.44 MPa and the tensile strain is about 1040%.

    参考文献
    相似文献
    引证文献
引用本文

孙广东, 马军翔, 吕玲玲, 王 恒, 黄 益.蓝光聚合交联超吸水高强水凝胶的制备及性能[J].高分子材料科学与工程,2020,36(11):7-16. Guangdong Sun, Junxiang Ma, Lingling Lü, Heng Wang, Yi Huang. Preparation and Properties of Superabsorbent and High-Strength Poly(acrylic acid) Hydrogel Based on Blue Light Initiated Photopolymerization[J]. Polymer Materials Science & Engineering,2020,36(11):7-16.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2021-02-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司