动态硫化丁基橡胶/聚丙烯热塑性硫化胶的相态结构演变及阻尼性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

山东省自然科学基金资助项目(ZR2016XJ002)


Morphology Structure Evolution and Damping Properties of Dynamic Vulcanized Butyl Rubber/Polypropylene Thermoplastic Vulcanizate
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过动态硫化方法制备了丁基橡胶/聚丙烯热塑性硫化胶(IIR/PP-TPV),研究了动态硫化过程中交联度、橡塑两相相态结构和PP相晶体结构的演变,并用动态力学热分析方法测试了IIR/PP-TPV橡塑两相相容性和阻尼性能。结果表明,随着动态硫化时间的延长,体系的交联度逐渐增加,当动态硫化时间为90 s时,交联度趋于稳定,拉伸强度达到最大值,扭矩值先增加后减小。动态硫化过程中橡塑两相由双连续相演变为海岛相结构,IIR橡胶相交联颗粒粒径由10 μm减小到2 μm左右;PP相的晶体尺寸减小,分布变得均一,X射线衍射分析表明动态硫化过程不会改变PP相的晶型结构。相态演变过程中,IIR/PP-TPV由2个转变为1个tanδ峰值,橡塑两相相容性提高;随着动态硫化的进行,Tg向高温方向偏移,Tp值增大,阻尼温域变宽。循环回收4次后,拉伸强度和断裂伸长率保持率达88%和86%;IIR交联颗粒粒径变大,连续的PP相为IIR/PP-TPV提供了优异的可重复加工性能。

    Abstract:

    The butyl rubber/polypropylene thermoplastic vulcanizate (IIR/PP-TPV) was prepared by dynamic vulcanization method. The degree of cross-linking, the morphology structure of rubber-plastic phase and the crystal structure of PP during dynamic vulcanization were studied. The two-phase compatibility and damping properties of IIR/PP-TPV were investigated through DMA. The results show that with the increase of dynamic vulcanization time, the degree of cross-linking of the system increases gradually. When the dynamic vulcanization time is 90 s, the degree of cross-linking tends to be stable, the tensile strength reaches the maximum value, and the torque value increases first and then decreases. During the dynamic vulcanization process, the two phases of rubber and plastic change from double continuous phase to island phase structure. The crosslinked particles of IIR rubber phase decrease from 10 μm to about 2 μm. The crystal size of PP phase decreases and the distribution becomes more uniform. XRD analysis indicate that the dynamic vulcanization process does not change the crystalline structure of PP phase. During the morphology structure evolution, IIR/PP-TPV changes from two to one tan δ peak, and the compatibility between rubber and plastic is improved. With the progress of dynamic vulcanization, Tg shifts toward high temperature, and the damping temperature range becomes wider.After 4 cycles of recycling, the retention of tensile strength and elongation at break reaches 88% and 86%, respectively; the particle size of IIR particles becomes larger, and the continuous PP phase provides excellent the repeatable processing for IIR/PP-TPV.

    参考文献
    相似文献
    引证文献
引用本文

汤 琦, 郎秀瑞, 韩立静, 赵 文, 王春芙, 宗成中.动态硫化丁基橡胶/聚丙烯热塑性硫化胶的相态结构演变及阻尼性能[J].高分子材料科学与工程,2020,36(11):93-100. Qi Tang, Xiurui Lang, Lijing Han, Wen Zhao, Chunfu Wang, Chengzhong Zong. Morphology Structure Evolution and Damping Properties of Dynamic Vulcanized Butyl Rubber/Polypropylene Thermoplastic Vulcanizate[J]. Polymer Materials Science & Engineering,2020,36(11):93-100.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2021-02-09
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司