氧化钕改性树脂传递模塑聚酰亚胺树脂的热氧化稳定性
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Thermo-Oxidative Stability of RTMable Polyimide Resin Modified with Neodymium Oxide
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用纳米氧化钕(Nd2O3)为热氧化稳定性的改性剂,利用机械共混方法制备了氧化钕改性的树脂传递模塑(RTM)聚酰亚胺低聚物,经375 ℃高温固化获得了改性RTM聚酰亚胺树脂,研究了氧化钕含量对RTM聚酰亚胺树脂的热氧化稳定性、工艺性能和力学性能的影响。结果表明,一定量氧化钕的加入能够显著提高RTM聚酰亚胺树脂的热氧化稳定性,随着氧化钕含量增加,热氧化稳定性和拉伸强度先升高后下降,当氧化钕填充含量为1%时,RTM聚酰亚胺树脂在350 ℃老化150 h的老化失重率降低幅度可达64%,拉伸强度则提高了42%,同时对流变性能影响较小,显示了良好的改性效果。

    Abstract:

    The modified RTMable polyimide oligomer was prepared by the mechanical blending method by using nano-scale neodymium oxide (Nd2O3) as modifier to improve the thermo-oxidative stability, and the modified RTM polyimide resin was cured under high-temperature. The effects of neodymium oxide content on the thermo-oxidative stability, mechanical and rheological properties of RTMable polyimide resins were investigated. The results indicate that the addition of a certain amount of the neodymium oxide could significantly improve the thermo-oxidative stability of RTMable polyimide resins, the thermal-oxidative stability and tensile strength are increased first and decreased afterward with the increase of neodymium oxide content, when the filling content of the neodymium oxide is 1%, the mass loss ratio of the RTMable polyimide resin is decreased by 64% after aging at 350 ℃ for 150 h, while the tensile strength is increased by 42% compared with unmodified polyimide, and little effect on the rheological properties of polyimide is observed, which exhibit a dramatically good modification effect.

    参考文献
    相似文献
    引证文献
引用本文

张 朋, 姜卓钰, 钟翔屿, 包建文.氧化钕改性树脂传递模塑聚酰亚胺树脂的热氧化稳定性[J].高分子材料科学与工程,2020,36(12):21-26. Peng Zhang, Zhuoyu Jiang, Xiangyu Zhong, Jianwen Bao. Thermo-Oxidative Stability of RTMable Polyimide Resin Modified with Neodymium Oxide[J]. Polymer Materials Science & Engineering,2020,36(12):21-26.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2021-03-25
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司