聚乙烯亚胺修饰氧化石墨烯改性水性聚氨酯的制备及抗菌性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

2018年度安徽省科技重大专项(18030901077)


Preparation and Antibacterial Properties of Waterborne Polyurethane Modified by Polyethyleneimine and Graphene Oxide
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用改进的Hummers法制备氧化石墨烯(GO),用聚乙烯亚胺(PEI)还原GO得到了PEI-GO复合材料,再通过共混法制备出PEI-GO改性的水性聚氨酯(PGWPU)复合材料。红外光谱、X射线光电子能谱和X射线多晶体衍射测试表征了PEI的成功引入。由于PEI-GO的加入,使得PGWPU复合胶膜的力学性能得到了很大提高,加入1.0%的PEI-GO后,PGWPU的拉伸强度和断裂伸长率较纯水性聚氨酯分别提高了131.88%和62.55%。以大肠杆菌(E.coil)为测试菌种,通过贴膜法表征了胶膜的抗菌性。结果表明,当PEI-GO质量分数为0.2%时,胶膜对大肠杆菌的抗菌率为99.9%。

    Abstract:

    Graphite oxide (GO) was prepared by improved Hummers method, PEI-GO composites were prepared by reducing GO with polyethyleneimine (PEI), and PEI-GO modified waterborne polyurethane (PGWPU) composites were prepared by blending method. The successful introduction of PEI was characterized by FT-IR, XPS and XRD. Due to the addition of PEI-GO, the mechanical properties of PGWPU composite films are greatly improved. After adding 1.0% PEI-GO, the tensile strength and elongation at break of PGWPU are increased by 131.88% and 62.55% respectively compared with pure waterborne polyurethane. E. coli was used as test strain, and the antimicrobial activity of the films was characterized by the method of coating. The results show that when the PEI-GO mass fraction is 0.2%, the antibacterial rate of the film to E.coli is 99.9%.

    参考文献
    相似文献
    引证文献
引用本文

于倩倩, 杨建军, 吴庆云, 吴明元, 张建安, 刘久逸.聚乙烯亚胺修饰氧化石墨烯改性水性聚氨酯的制备及抗菌性能[J].高分子材料科学与工程,2021,37(2):124-129. Qianqian Yu, Jianjun Yang, Qingyun Wu, Mingyuan Wu, Jian’an Zhang, Jiuyi Liu. Preparation and Antibacterial Properties of Waterborne Polyurethane Modified by Polyethyleneimine and Graphene Oxide[J]. Polymer Materials Science & Engineering,2021,37(2):124-129.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2021-05-06
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司