Abstract:Silicon carbide whisker with amino groups (NH2-SiCw) and boron nitride with epoxy groups (Epoxy-BN) were obtained by surface treatment of silicon carbide whisker (SiCw) with γ-aminopropyltriethoxysilane (KH550) and boron nitride (BN)γ-(2,3-glycidoxy)propyltrimethoxysilane (KH560), respectively. With the increase of the in-situ reaction time and reaction temperature of NH2-SiCw and Epoxy-BN in the silicone rubber matrix, the thermal conductivity of the composites increases. The effect of the pre-reaction time of NH2-SiCw and Epoxy-BN in xylene on the thermal conductivity of the composites, as well as the sectional morphologies of the composites shows that the in-situ reaction between NH2-SiCw and Epoxy-BN occurs in silicone rubber. The thermal conductivity of the composites reaches 2.23 W/(m·K) during the in-situ reaction for 15 min, which is 7.7% higher than that of without the in-situ reaction. At this time, the tensile strength and volume resistivity of the composites are 2.35 MPa, 3.7×1013 Ω·cm, respectively.