Abstract:Heptaisobutyl polyhedral oligomeric silsesquioxane double-end functionalized polybutadiene (POSS-PB-POSS) was synthesized using dilithium as initiator, chloropropyl heptyl isobutyl polyhedral oligomeric silsesquioxane (Cl-POSS) as terminator, butadiene as monomer, cyclohexane as solvent, tetrahydrofuran (THF) as structure modifier via living anionic polymerization. The structure of POSS-PB-POSS was characterized by 1H-NMR and 31C-NMR. The results clearly prove that the reaction of poly(butadienyl)dilithium with Cl-POSS was carried out and POSS-PB-POSS was successful synthesized. Molecular weight, molecular weight distribution of POSS-PB-POSS were measured by gel permeation chromatography (GPC). GPC results show that the production of dimeric side-products only can be prevented by adding DPE or St before end functionalization reaction. Subsequently POSS-PB-POSS composites filled with silica (SiO2) were prepared by solvent method and the bound rubber content of PB-POSS was measured. The stripping test indicates that the bound rubber content of POSS-PB-POSS samples is significantly higher than that of pure PB, more than five times. Then, the thermal stability of POSS-PB-POSS was studied further by steam stripping and thermogravimetric analysis (TGA). The results show that after stripping, there is no change in the GPC curves, especially, there are no multi-peaks, which proves that the end groups of POSS-PB-POSS are very stable. TGA results show that the thermal degradation temperature of stripping POSS-PB-POSS is higher than of pure PB, while the mass loss rate of POSS-PB-POSS is lower than of pure PB, proving again the significant increase in the thermal stability of POSS-PB-POSS.