钛酸钡/硅橡胶与多壁碳纳米管/硅橡胶交替多层复合材料的设计及电机转换性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51703053);湖北工业大学博士科研启动基金(BSQD14007)


Design and Electromechanical Properties of Multi-Layered Composites Consisting of Alternating Barium Titanate/Silicone and Multi-Walled Carbon Nanotube/Silicone Layers
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    分别以钛酸钡(BT)和多壁碳纳米管(MWCNT)作为硅橡胶(SR)的填料,采用多次涂覆法,设计并制备了BT/SR和MWCNT/SR交替多层结构的复合介电弹性体B/SR-M/SR,研究了B/SR-M/SR复合材料的电机转换性能及交替多层结构对其性能的影响。结果表明,B/SR-M/SR复合材料的杨氏模量略高于纯SR,且表现出高介电常数、低介电损耗的特点。在1 kHz下,B/SR-M/SR的介电常数最大为5.6,为纯SR(3.2)的1.77倍,而相应的介电损耗为0.003,与纯SR(0.001)接近。MWCNT含量对复合材料的电导特性无显著影响,但会降低其击穿场强。B/SR-M/SR的最大电致应变为7.37%,远高于纯SR(1.43%)。此外,对比填充相同含量填料的三相复合材料,B/SR-M/SR复合材料的电机转换性能更佳。

    Abstract:

    Multi-layered nanocomposites B/SR-M/SR with alternating layers consisting of barium titanate filled and multi-walled carbon nanotube filled silicone (BT/SR and MWCNT/SR) were designed and prepared via repeated coating method. Electromechanical properties of the composite dielectric elastomers were thoroughly investigated and the effect of multi-layered structure on them were examined. Results show that elastic moduli of the composites are higher than that of neat silicone rubber and they all show favorable characteristics of high dielectric permittivities and low dielectric losses. The highest permittivity of the multi-layered B/SR-M/SR composites is 5.6 combined with a low dielectric loss of 0.003. The former is 1.77 times higher than neat silicone, while the latter shows no obvious increase compared with neat silicone. The content of MWCNT shows no significant influence on the conductivity of the composites, though it can decrease their dielectric breakdown strength. The largest electromechanical strain of the multi-layered B/SR-M/SR composites is 7.37%, much higher than of neat silicone (1.43%). Meanwhile, the multi-layered B/SR-M/SR shows better electromechanical performance than non-layered, BT and MWCNT co-filled counterparts.

    参考文献
    相似文献
    引证文献
引用本文

张岩婷, 蔡 诚, 陈 韬, 张淑妍, 胡 涛, 吴崇刚, 龚兴厚, 郑 譞.钛酸钡/硅橡胶与多壁碳纳米管/硅橡胶交替多层复合材料的设计及电机转换性能[J].高分子材料科学与工程,2021,37(12):128-136. Yanting Zhang, Cheng Cai, Tao Chen, Shuyan Zhang, Tao Hu, Chonggang Wu, Xinghou Gong, Xuan Zheng. Design and Electromechanical Properties of Multi-Layered Composites Consisting of Alternating Barium Titanate/Silicone and Multi-Walled Carbon Nanotube/Silicone Layers[J]. Polymer Materials Science & Engineering,2021,37(12):128-136.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-04-02
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司