环保型增塑聚氯乙烯的热响应形状记忆性能与机理
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

四川省科技厅应用基础研究项目(2020YJ0095)


Thermal-Responsive Shape-Memory Effect and Mechanism of the Environment-Friendly Plasticized Poly(vinyl chloride)
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用环保型增塑剂乙酰基柠檬酸三丁酯(ATBC)制备了具有较宽玻璃化转变温域的增塑聚氯乙烯(PVC),研究了开关温度(Ts)的选择对材料形状记忆性能的影响。增塑PVC的形状固定率始终接近100%,与T2大小无关,但当Ts从70 ℃升高到100 ℃,形状回复率由91.5%降至85.5%,回复速率和回复应力也同时劣化。在低的Ts下进行同条件拉伸时,增塑PVC高的储能模量赋予其更强的弹性能贮存能力,可提供更大的回复应力,进而加速回复过程。机理研究表明,增塑PVC的形状记忆效应源于微晶和无定形分子链的协同作用,PVC微晶作为物理交联点,充当固定相,其结构和含量在形状记忆前后不变,无定形分子链基于Ts的选定划分为软链和硬链部分,分别充当可逆相和第二固定相。提高Ts会增大软链比例,加剧分子链滑移,而硬链的减少弱化了固定相对分子链滑移的抑制作用,最终导致形状回复率的降低。

    Abstract:

    Acetyl tributyl citrate (ATBC), an environment-friendly plasticizer, was used to prepare plasticized poly(vinyl chloride) (PVC) with a wide glass transition range. The influence of the switching temperature (Ts) on the shape-memory effect of this material was studied. The shape-fixing ratio of plasticized PVC is always close to 100%, regardless of the choice of Ts. However, the shape-recovering ratio decreases from 91.5% to 85.5 % when Ts increases from 70℃ to 100℃, accompanied by the deterioration of recovery speed and recovery stress. As stretched under the same conditions at low Ts, the larger storage modulus of plasticized PVC enables better performance in storing elastic energy, thus can provide more recovery stress and accelerate the recovery process. The research on the operative mechanism shows that the shape-memory effect of plasticized PVC originates from the synergistic effect of microcrystals and amorphous molecular chains. The PVC microcrystals can act as permanent phase and serve as physical cross-linking points because of their unchanged structure and content before and after shape-memory cycle. The amorphous domain is divided into two parts of soft chain and hard chain based on Ts, which act as the reversible phase and the second permanent phase, respectively. Increasing Ts will increase the proportion of soft chains and aggravate molecular chain slippage. At the same time, the reduction of hard chains weakens the inhibitory effect of stationary phase to molecular chain slippage, which ultimately leads to a decrease in shape-recovering ratio.

    参考文献
    相似文献
    引证文献
引用本文

杨丽华, 郑 宇, 沈佳斌, 郭少云.环保型增塑聚氯乙烯的热响应形状记忆性能与机理[J].高分子材料科学与工程,2022,38(3):48-55. Lihua Yang, Yu Zheng, Jiabin Shen, Shaoyun Guo. Thermal-Responsive Shape-Memory Effect and Mechanism of the Environment-Friendly Plasticized Poly(vinyl chloride)[J]. Polymer Materials Science & Engineering,2022,38(3):48-55.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-06-14
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司