Abstract:Membrane fouling is one of the bottlenecks restricting the rapid development of membranes. How to inhibit the adhesion and growth of microorganism on membrane surface from the source has become one of the hot spots in membrane fouling research. In this study, polyamide reverse osmosis composite membranes were prepared by interfacial polymerization of m-phenylenediamine and trimesoyl chloride using polysulfone ultrafiltration membrane as support layer. Polyethyleneimine (PEI) was used to optimize and modify the antibacterial performance of reverse osmosis composite membranes by sequential interfacial polymerization. The influence of PEI reaction parameters on membrane performance was investigated, and the optimal parameters were determined. The molecular structure, surface properties and membrane performances of the fabricated membranes were studied. The results show that when the mass fraction of PEI is 2%, the reaction time is 60 s, and the heat treatment is 100 ℃ for 5 min, the membrane has the best performance. The increasing of hydrophilicity and charge of membrane surface contribute to the improvement of membrane performance. Compared to the original membrane, the salt rejection of the prepared membranes is improved from 96.6% to 98.9% and the water flux is increased from 35.7 L/(m2·h) to 49.9 L/(m2·h). Gram-negative Escherichia coli and Gram-positive Staphylococcus were selected to evaluate the antibacterial properties of the membranes. The bacterial killing rate of the fabricated membranes against the two kinds of bacteria could reach 95.8% and 96.3% respectively, indicating that the separation and antibacterial performance could be improved simultaneously through the modification using PEI.