环氧基改性蒙脱土增容聚乳酸/聚丁二酸丁二醇酯共混体系
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51703054);大学生创新创业训练计划项目(201910500003)


Compatibilization of Poly(lactic Acid)/Poly(butylene succinate) Blend Using Epoxy Based Modified Montmorillonite
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    通过加成反应合成十八烷基二甲基环氧基氯化铵,并与钠基蒙脱土进行离子交换反应得到环氧基改性蒙脱土(OMMT)。将OMMT以熔融共混的方式加入聚乳酸/聚丁二酸丁二醇酯(PLA/PBS)共混物中,研究了OMMT含量对PLA/PBS共混体系的增容效果及对力学性能的影响。微观结构表明,添加OMMT到PLA/PBS(80/20)共混物中之后,分散相PBS的粒径显著降低,并且粒径分布变窄。在PLA与PBS的相界面处,OMMT以插层或剥离的形式存在,阻止分散相聚集,增加两相之间的相容性。动态流变结果表明,由于OMMT对分子链的缠结作用,PLA/PBS/OMMT复合材料的储能模量、损耗模量和复数黏度都随着OMMT含量增加而增加。动态力学热分析表明,PLA与PBS的玻璃化转变温度相互靠拢的幅度随着OMMT含量的增加而增大。力学性能结果表明,当OMMT质量分数为1%时,PLA/PBS/OMMT复合材料的拉伸强度达到62.5 MPa、冲击强度达到3.1 kJ/m2,相较于纯PLA/PBS共混物分别提高了32.1%和19.2%。

    Abstract:

    Epoxypropyl octadecyl dimethyl ammonium was synthesized by addition reaction, and then ion- exchange reacted with sodium-based montmorillonite to obtain epoxy-based organically modified montmorillonite (OMMT). OMMT was incorporated into poly(lactic acid)/poly(butylene succinate) (PLA/PBS) blend by melt blending. The effect of OMMT contents on compatibilization and mechanical properties of PLA/PBS blends were investigated. The microstructure show that the particle size of the dispersed phase PBS is reduced significantly with the addition of OMMT in PLA/PBS(80/20) blends, and the size distribution becomes narrow. OMMT exists in the form of intercalation or exfoliation at the phase interface between PLA and PBS, resulting in the reduction of dispersed phase coalescence and increase of compatibility between PLA and PBS. The dynamic rheological results show that storage modulus, loss modulus and complex viscosity of PLA/PBS/OMMT composites increase with the increase of OMMT content due to the entanglement effect of OMMT to molecular chain. The dynamic thermo- mechanical property results show that the glass transition temperatures of PLA and PBS close to each other evidently with the increase of OMMT content. The results of mechanical properties show that the tensile strength and impact strength of PLA/PBS/OMMT composite are 62.5 MPa and 3.1 kJ/m2 respectively when the mass fraction of OMMT is 1% , which are 32.1% and 19.2% higher than those of the pure PLA/PBS blend.

    参考文献
    相似文献
    引证文献
引用本文

吕若昀,田 瑶,张 杰,勾良程,邹 源,余 鹏.环氧基改性蒙脱土增容聚乳酸/聚丁二酸丁二醇酯共混体系[J].高分子材料科学与工程,2022,38(4):80-88. Ruoyun Lü, Yao Tian, Jie Zhang, Liangcheng Gou, Yuan Zou, Peng Yu. Compatibilization of Poly(lactic Acid)/Poly(butylene succinate) Blend Using Epoxy Based Modified Montmorillonite[J]. Polymer Materials Science & Engineering,2022,38(4):80-88.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-07-23
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司