超声波与可调正应力协同混合装置的研制及尼龙6/碳纤维复合材料制备
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

广东省自然科学基金资助项目(2021A1515010487,2021A1515012609)


Development of a Mixer Under the Synergy of Ultrasonic Wave and Adjustable Normal Stress and Preparation of Nylon 6/Carbon Fiber Composites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    提出一种超声波与可调正应力协同作用的新型混合方法及相应装置。通过调节该装置内定子和转子轴之间的偏心距(e2)可以调控物料受到的压缩/拉伸应力大小以适合不同的材料体系,同时改变偏心距(e2)还可调节熔体厚度以匹配超声波的有效作用范围,实现了超声波与正应力协同的熔融混合。利用该装置制备了尼龙6(PA6)/碳纤维(CF)复合材料。扫描电镜和光学显微镜图像表明,在超声波和正应力的协同作用下CF(质量分数25%)均匀分散在基体中且纤维平均保留长度达到291 μm;施加超声波后复合材料的拉伸强度和模量分别提高41.4%与30.4%;适当的超声作用使得复合材料电导率提升到8.76×10-3 S/m,且逾渗阈值下降超过5%。新设备为高性能聚合物基纤维增强复合材料的制备提供了新途径。

    Abstract:

    A new type of mixing method under synergy of ultrasonic wave and adjustable normal stress and its corresponding mixing device were reported. The ratio of compressive/elongational stress could be adjusted by changing the eccentricity (e2) of the internal stator and rotor axis to match different material systems. At the same time, the melt thickness could also be regulated by changing the eccentricity (e2) to match the effective range of ultrasonic wave, which realized the synergistic melt mixing of ultrasonic wave and normal stress. Nylon 6 (PA6)/ carbon fiber (CF) composites were prepared by melt compounding using this device. SEM and optical microscope images show that CF (mass fraction of 25% ) is uniformly dispersed in matrix, and reaching an average retention length of 291 μm under the synergy of ultrasonic wave and normal stress. After superimposing the ultrasonic wave, the tensile strength and modulus of composites are increased by 41.4% and 30.4% , respectively. And appropriate ultrasonic wave increases the electrical conductivity of composites to 8.76×10-3 S/m and the percolation threshold is reduced by more than 5%. This new equipment provides a new strategy for the preparation of polymer-based fiber- reinforced composites with high performance.

    参考文献
    相似文献
    引证文献
引用本文

殷小春, 汪棋, 何光建, 冯彦洪.超声波与可调正应力协同混合装置的研制及尼龙6/碳纤维复合材料制备[J].高分子材料科学与工程,2022,38(8):147-153. Xiaochun Yin, Qi Wang, Guangjian He, Yanhong Feng. Development of a Mixer Under the Synergy of Ultrasonic Wave and Adjustable Normal Stress and Preparation of Nylon 6/Carbon Fiber Composites[J]. Polymer Materials Science & Engineering,2022,38(8):147-153.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-11-02
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司