Abstract:In this study, copper wire was used as nozzle electrode to design and build a set of linear free liquid surface electrospinning experimental device. An L9(34) orthogonal experiment was designed to study the effects of four major process parameters, namely, polymer solution concentration, input voltage, spinning distance and nozzle rotation speed on the morphology and distribution of PVDF nanofibers. The multiple quadratic regression equation between the process parameters and average diameter of nanofibers was established, and the influence of single factor was analyzed. The average diameter of the nanofibers obtained in the experiments is 192~443 nm, and the relative standard deviation is 32.5%~53.75%. The results show that under certain conditions, the average diameter of PVDF nanofibers increases with the increase of polymer concentration and voltage, and decreases with the increase of spinning distance and nozzle rotation speed. According to variance and range analysis, the concentration of polymer solution has the greatest influence on the average diameter of nanofibers, followed by the spinning distance and nozzle rotation speed, while the input voltage has a relatively low influence on the MFD of nanofibers.