聚醚醚酮和纳米二氧化硅改性聚四氟乙烯复合材料的摩擦学性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Tribological Properties of Polyetheretherketone and Nano-SiO2 Filled Polytetrafluoroethylene Composites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为了研究干摩擦条件下聚醚醚酮(PEEK)和纳米二氧化硅(nano-SiO2)填充改性聚四氟乙烯(PTFE)复合材料的摩擦磨损机理,采用共混-冷压-烧结的工艺制备了试样,在LSR-2M型往复摩擦磨损实验机上进行摩擦磨损试验。利用扫描电子显微镜(SEM)和非接触式白光干涉3D 轮廓仪表征了对偶表面转移膜及磨痕的微观形貌,X 射线光电子能谱分析(EDS)了对偶表面的元素分布,从微观角度揭示了PTFE 复合材料的摩擦磨损机理。结果表明,单独填充PEEK 和纳米SiO2 填料后,PTFE 复合材料的摩擦磨损性能均可得到改善。其中20% PEEK-PTFE 复合材料的体积磨损率仅为2.6×10-6 mm3(/ N·m),15%PEEK-PTFE 复合材料的平均摩擦系数为0.18。PEEK 减磨效果优于纳米SiO2,PEEK 和纳米SiO2 复配填充能够协同改进PTFE 复合材料的摩擦学性能。经过5 h 磨损,15%PEEK-PTFE 复合材料体积磨损率下降至2.7×10-6 mm3(/ N·m),3%纳米SiO2-15%PEEK-PTFE复合材料的体积磨损率下降至4.3×10-6 mm3(/ N·m)。增大对偶表面粗糙度后,2 种复合材料的体积磨损率均增大,而平均摩擦系数均减小。

    Abstract:

    In order to study the friction and wear mechanism of polyetheretherketone(PEEK) and nano-SiO2 filled polytetrafluoroethylene(PTFE) composites under dry friction condition, the friction and wear tests were carried out on LSR- 2M reciprocating friction and wear tester. The samples were prepared by the blending- cold pressing- sintering process. Scanning electron microscope (SEM) and non-contact 3D profiler were used to characterize the microscopic morphology of the transfer film and wear track on the counterpart surface, and the X- ray energy spectrum analysis (EDS) was used to characterize the elements distribution on the counterpart surface. The results show that the friction and wear properties of PTFE composites can be improved with PEEK and nano-SiO2 filled separately. Among them, the volume wear rate of 20% PEEK-PTFE composite is only 2.6×10-6 mm3/(N? m), and the mean friction coefficient of 15% PEEK-PTFE composite is 0.18. The antifriction effect of the composite filled with nano-SiO2 is not as good as that filled with PEEK, but when they are filled together, the tribological properties of PTFE composites can be synergistically improved. After 5 h wear, the volume wear rate of 15%PEEK-PTFE composite reduces to 2.7×10-6 mm3/(N ? m), and 3% nano-SiO2-15%PEEK-PTFE composite reduces to 4.3×10 mm /(N? m). When the counterpart surface roughness is increased, the volume wear rate of the two composites is increased, but the mean friction coefficient is decreased.

    参考文献
    相似文献
    引证文献
引用本文

卢国库,龚俊,高贵,王宏刚,彭一超.聚醚醚酮和纳米二氧化硅改性聚四氟乙烯复合材料的摩擦学性能[J].高分子材料科学与工程,2022,38(8):168-176. Guoku Lu, Jun Gong, Gui Gao, Honggang Wang, Yichao Peng. Tribological Properties of Polyetheretherketone and Nano-SiO2 Filled Polytetrafluoroethylene Composites[J]. Polymer Materials Science & Engineering,2022,38(8):168-176.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-11-02
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司