纳米二氧化硅表面接枝反应性相容剂协同增容聚苯乙烯/聚酰胺6
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金资助项目(51103135);浙江省人才项目(2019R52012)


Synergistic Compatibilization of Polystyrene / Polyamide 6 by Grafting Reactive Compatibilizer on Nano-SiO2 Surface
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对聚苯乙烯(PS) 和聚酰胺6 (PA6) 热力学不相容引起共混物力学性能降低的问题,文中首先制得纳米SiO2 表面接枝苯乙烯(St)与3-异丙烯基-α,α,-二甲基苄基-异氰酸酯(TMI) 共聚物为新型相容剂,并用于PS/PA6 体系的反应性协同增容。扫描电镜和透射电镜分析结果表明,通过无机纳米粒子和异氰酸酯基团原位增容的协同作用可调控相容剂选择性分布,使两相界面张力减小,实现分散相PA6 尺寸的降低、共混物相容性的提升。设计了不同异氰酸酯基团含量的相容剂,当添加量较少时( 质量分数0.5%) ,拉伸强度最高增加了125.5%、断裂伸长率提升了128.1%,有效改善了PS/PA6 由于热力学不相容引起的力学性能不佳的问题。

    Abstract:

    The use of modified inorganic nanoparticles as compatibilizer for thermodynamically incompatible systems attracted much attention. However, the research of the influence of the grafting rate of reactive groups on the surface of inorganic nanoparticles on the compatibility and mechanical properties was relatively lacking. In this study, a typical polystyrene (PS) and polyamide 6 (PA6) incompatible system was selected as blending system to study the influence of the grafting rate of different reactive groups on the compatibility, and in order to solve the thermodynamic incompatibility caused by PS and PA6 which results in the problem of reduced mechanical properties of blends. Firstly, the surface of nano SiO2 grafted with the copolymer of styrene (St) and 3- isopropenyl- α,α,-dimethylbenzyl-isocyanate (TMI) was prepared as an new type of compatibilizer and used for the reactive synergistic compatibilization of PS/PA6 system. FT-IR results prove the existence of reactive groups (-NCO) and PS on the silica surface. The proportion of reactive monomers in the grafted copolymer molecular chain was obtained by chemical titration, and it is found that there is a positive correlation between the feed ratio of reactive monomers and the grafting rate. The results of TG and DSC verify the existence of grafted molecular chains on the surface of nano silica. Combined with the results of GPC, it is found that the addition of TMI reduces the molecular weight of the grafted chains and make the grafted chains more susceptible to thermal decomposition, but the decomposition temperature is much higher than the processing temperature in this study. Scanning electron microscope and transmission electron microscope results show that the selective distribution of the compatibilizer is controlled by the synergistic effect of the in- situ compatibilization of the isocyanate groups and inorganic nanoparticles and the interfacial tension of the two phases is reduced, so that the size of the dispersed phase PA6 is reduced and the compatibility is improved. Compatibilizers with different isocyanate group contents were prepared. When the added amount is small (mass fraction of 0.5%), the maximum of tensile strength is increased by 125.5%, and the elongation at break is increased by 128.1%. The decrease of mechanical properties of PS/PA6 blends due to thermodynamic incompatibility is effectively improved.

    参考文献
    相似文献
    引证文献
引用本文

章泽民,包建娜,陈康,张先明,胡国华.纳米二氧化硅表面接枝反应性相容剂协同增容聚苯乙烯/聚酰胺6[J].高分子材料科学与工程,2022,38(10):72-80. Zemin Zhang, Jianna Bao, Kang Chen, Xianming Zhang, Guohua Hu. Synergistic Compatibilization of Polystyrene / Polyamide 6 by Grafting Reactive Compatibilizer on Nano-SiO2 Surface[J]. Polymer Materials Science & Engineering,2022,38(10):72-80.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2022-12-11
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司