Abstract:Recently, the potential of flexible pressure sensors to sense mechanical stimuli has sparked great interest in cutting-edge applications such as wearable electronics. Among them, capacitive pressure sensors have the advantages of ultra- fast response, low power consumption and small signal drift, and are considered to be the best choice for high-performance flexible sensors. At present, it is still very challenging for capacitive sensors to still have significant capacitance changes under large strains. This work reported the introduction of barium titanate (BaTiO3,BT) with high dielectric constant into porous dielectric layers. When the dielectric constant of the porous dielectric layer was measured by a dielectric spectrometer, it is found that the value increases from 2.51 to 3.83,it is beneficial to amplify the sensing signal (S=0.075 kPa-1).Aiming at the problem of poor cycle stability of this type of foam-based sensor due to the debonding of the filler and substrate in practical applications, this work tried to change the morphology of the filler to improve the above problems and initially achieved certain results. It is believed that this method can provide new ideas for the application of foam-based capacitive sensors in the field of flexible electronics.