Abstract:The low temperature nitrogen(N2)plasma was diagnosed using Langmuir probe to explore the variation of electron density with RF power, pressure and axial distance. The water contact angle was used to characterize the change of hydrophilicity before and after modification and to explore the optimal conditions for modified D- polylactic acid (PDLA) films. The changes in surface morphology, crystal structure, thermal stability properties and surface elements of PDLA films before and after modification were characterized through scanning electron microscopy (SEM), X- ray diffraction (XRD), thermogravimetric analysis (TGA) and X- ray photoelectron spectroscopy (XPS). The changes of mechanical properties and barrier properties of PDLA films before and after modification were characterized by measuring tensile strength, elongation at break and light transmission rate. The experimental results show that the contact angle of PDLA film is decreased from 89.53° to 49.96° under the optimal conditions (RF power 100 W, pressure 25 Pa, modification time 180 s, axial distance 10 cm); the mechanical properties of PDLA film are decreased slightly after modification, and the tensile strength and elongation at break at the center of discharge are decreased by 26.31% (transverse) 24.41% (longitudinal) and 29.41% (transverse) 28.1% (longitudinal); the thermal stability increases slightly compared with the original film, and the barrier properties remain basically unchanged; the contact angle of PDLA film is increased continuously with the increase of storage time. When stored for 30 d, the samples all still retain some of their improved hydrophilicity.