Abstract:Spherical polytetrafluoroethylene(PTFE) and in- situ fibrillary PTFE reinforced PP composites were prepared by one- step melt blending method. Then pristine PP, spherical PTFE reinforced PP(PP/S- PTFE) and in- situ fibrillary PTFE reinforced PP(PP/F- PTFE) foams were fabricated by self- developed batch foaming system. Scanning electron microscopy (SEM) and photo thermal induced infrared microscope reveal that the extended chain crystal structure and surface modification of PTFE are the critical factors which lead to the in-situ fibrillation of PTFE. X-ray diffraction (XRD) results show that PP, PP/S-PTFE and PP/F-PTFE all present α crystal structure. The expansion ratio firstly increases and then decreases with the increased temperature at a given pressure, however, the foaming temperature range is extended to lower temperature by 10 ℃ when the pressure increases from 5 MPa to 15 MPa. The maximum expansion ratio of PP/PTFE composites is reduced with the incorporation of in- situ PTFE fibril, yet it is beneficial to the optimization of cell structure and improvement of mechanical properties. According to the SEM observation and compressive test, PP/F-PTFE foams exhibit the smallest cell size, the highest cell population density and the best standard deviation of cell size, the compressive strength of PP/F-PTFE foams is higher than that of PP foams by 123% with the same expansion ratio.