有机硅改性酚醛气凝胶的制备及隔热疏水性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Preparation, Thermal Insulation and Hydrophobic Properties of Silicone-Modified Phenolic Aerogel
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    酚醛(PR)气凝胶具有低密度和低导热等突出优点,广泛用作隔热、保温材料。然而,传统的PR气凝胶制备工艺复杂,且与生俱来地存在易吸湿的弊端。文中以线型酚醛树脂为原料、辛基三乙氧基硅烷(OTES)为疏水剂,分别通过化学接枝法和物理共混法制备了硅改性酚醛树脂,进一步借助溶胶-凝胶和常压干燥工艺制备了硅改性酚醛气凝胶。采用扫描电子显微镜和能谱分析、N2吸附-脱附实验、同步热分析、热常数和疏水角测量对气凝胶进行表征,并通过水浸泡实验评估其吸水性能。所制备的试样密度在0.205~0.260 g/cm3、热导率在0.040~0.044 W/(m·K)。研究表明,引入OTES在不同程度上改善了PR气凝胶的热稳定性、疏水性和隔热性能,且化学接枝法的综合表现优于物理共混法。物理共混改性使气凝胶的高温残重率提高约 5%,疏水角提高约 121.0°,在水中的饱和吸湿率为 59.6%(改性前高达349.5%);而通过化学接枝路线添加少量的OTES即可大幅度提升气凝胶性能,残重率增加约10%、疏水角达153.4°、饱和吸湿率仅19.6%。

    Abstract:

    Phenolic (PR) aerogel has outstanding advantages such as low density and low thermal conductivity, which is widely used as thermal insulation material. The traditional preparation processes of PR aerogel are complex, and PR aerogel is inherently hygroscopic. In this study, silicon- modified phenolic resins were prepared by chemical grafting and physical blending using linear phenolic resin as raw material and octyltriethoxysilane (OTES) as hydrophobic modifier, and then silicon-modified phenolic aerogels were prepared by sol-gel and atmospheric pressure drying process. The aerogels were characterized by scanning electron microscopy and energy spectroscopy, N2 adsorption-desorption experiment, synchronous thermal analysis, thermal constant and hydrophobic angle measurement, and the water absorption performance was evaluated by water immersion experiment. The density of the prepared samples is between 0.205~0.260 g/cm3, and the thermal conductivities are 0.040~0.044 W/(m·K). The results show that OTES improves the thermal stability, hydrophobicity and thermal insulation performance of PR aerogels, and the comprehensive performance of chemical grafting method is better than that of physical blending method. The physical blending modification increases the high temperature residual mass rate of aerogels by about 5%, the hydrophobic angle is increased by 129°, and the saturated moisture absorption rate in water is 59.6% (up to 349.5% before modification). The addition of a small amount of OTES through the chemical grafting route can greatly improve the performance of aerogels, the residual mass rate is increased by about 10%, the hydrophobic angle is 153.4°, and the saturation moisture absorption rate is only 19.6%.

    参考文献
    相似文献
    引证文献
引用本文

范佳敏,秦 岩,傅华东,薛宸沂,常 凯.有机硅改性酚醛气凝胶的制备及隔热疏水性能[J].高分子材料科学与工程,2023,39(10):29-39. Jiamin Fan, Yan Qin, Huadong Fu, Chenyi Xue, Kai Chang. Preparation, Thermal Insulation and Hydrophobic Properties of Silicone-Modified Phenolic Aerogel[J]. Polymer Materials Science & Engineering,2023,39(10):29-39.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2023-12-31
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司