聚乙二醇/石墨烯复合相变电热膜的制备与性能
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

科研基地-科技创新平台-新材料研究与开发(11011021001)


Preparation and Performance of Polyethylene Glycol/Graphene Composite Phase Change Electric Heating Film
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    文中采用价格低廉的多层石墨烯(MLG)为导电填料,潜热较高的聚乙二醇(PEG)相变材料为基体,通过溶液共混法制备了具有良好电热性能的复合相变电热膜。通过扫描电镜(SEM)、傅里叶变换红外光谱(FT-IR)、X射线衍射仪(XRD)、差示扫描量热分析(DSC)、热重分析(TGA)、升降温实验等分析了相变电热材料的表面形貌、结构性能、相变焓、热稳定性和电热性能。SEM 结果表明,MLG 与 PEG 基体中分散较好,并在 PEG 中构建了 MLG 杂化网络,其中MLG提供了导热路径,并限制了PEG在相变过程中的泄漏。FT-IR和XRD结果表明,在制备过程中,PEG与MLG之间没有发生化学反应,但PEG的结晶度有所降低。DSC和TGA分析表明,MLG质量分数为7%时,该复合相变材料相变焓为164 J/g,开始热失重温度为300 ℃左右。升降温实验表明电热膜具有可靠的温度调节性能,3 g PEG/MLG(7%)样品在20 V电压下可升温至91.3 ℃, 并且能在相变温度65 ℃附近保温280 s以上。

    Abstract:

    Energy- saving materials are nowadays research hotspots. In this paper, electrothermal films with good electrical properties were prepared by solution blending using multilayer graphene (MLG) with low cost as conductive filler and polyethylene glycol (PEG) with excellent latent heat performance as substrate. The surface morphology, structural properties, phase change enthalpy, thermal stability and electrothermal properties of the phase change electrothermal materials were analyzed by SEM, FT-IR, XRD, DSC, TGA and elevated temperature experiments. The SEM results show that the MLG is better dispersed in the PEG matrix and the MLG hybridization network is constructed in PEG, in which MLG provides the thermal conductivity path and limits the leakage of PEG during phase change process. The FT-IR and XRD results show that there is no chemical reaction between PEG and MLG during preparation process, but with the crystallinity of PEG reduced. And the DSC and TGA analysis show that the enthalpy of phase transition of the composite phase change material is 164 J/g at 7% MLG content, and the onset of heat loss temperature is about 300 ℃. The temperature rise and fall experiments show that the electric heating film has reliable temperature regulation performance, and the 3 g PEG/MLG (7% ) sample can be heated up to 91.3 ℃ at 20 V, and it can be held for more than 280 s near the phase transition temperature of 65 ℃.

    参考文献
    相似文献
    引证文献
引用本文

谢成西,刘太奇,赵 荣,吴飞翔,任 婕.聚乙二醇/石墨烯复合相变电热膜的制备与性能[J].高分子材料科学与工程,2024,40(6):47-55. Chengxi Xie, Taiqi Liu, Rong Zhao, Feixiang Wu, Jie Ren. Preparation and Performance of Polyethylene Glycol/Graphene Composite Phase Change Electric Heating Film[J]. Polymer Materials Science & Engineering,2024,40(6):47-55.

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 录用日期:
  • 网络出版日期:
  • 在线发布日期: 2024-08-28
  • 出版日期:
您是第      位访问者
编辑出版 :《高分子材料科学与工程》编辑部
地址 :四川省成都市一环路南一段24号 四川大学高分子研究所
电话 :028-8540 1653  E-mail:gfzclbjb@vip.sina.com
高分子材料科学与工程 ® 2026 版权所有
技术支持:北京勤云科技发展有限公司